Error code reference

Magic Chef Range Error Code F3-E0

Break in oven sensor circuit: open sensor, loose or disconnected sensor connector, or open wire in harness.

SourceRange - Tech Sheet: Wiring Diagrams & Circuits (9760092)p. 4-5

Diagnostic procedure

The full F3-E0 procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview

First diagnostic step

1. Verify failure if not displayed. Go to manual diagnostics screen 5 to view and clear error codes. 2. Use manual diagnostics screen 2 to view the status screen. 3. Check if temperature reads approximately room temperature.

SourceRange - Tech Sheet: Wiring Diagrams & Circuits (9760092)p. 4-5

Unlock with pass

More steps, wiring diagram references, and verified part numbers

Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.

Unlock F3-E0 procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

8 manuals in the MyPros+ library document this code for Magic Chef range.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

The full F3-E0 procedure

Where this code is documented

Models covered by the manuals that document this code

Related Magic Chef range error codes