Whirlpool Oven Error Code E2 F6

E2 F6 indicates a runaway temperature condition that occurred during the self-clean cycle. The oven reached or exceeded its maximum safe temperature threshold and the control system could not regulate the heat properly. This is a protective fault code designed to shut down the oven before thermal damage occurs. The most common cause is a relay on the control board that has welded closed, allowing constant power to the bake element.

You should not attempt to run another self-clean cycle until the fault has been diagnosed and repaired. Normal baking at lower temperatures may be possible in some cases, but if the underlying cause is a welded relay, the oven could overheat during any cooking mode. It is best to avoid using the oven until the faulty component has been identified and replaced.

Repair costs vary depending on the faulty component. An oven temperature sensor is typically the least expensive fix, with parts generally ranging from $20 to $60. A replacement control board is the more costly repair, with parts often falling in the $150 to $350 range depending on the model. Adding professional labor will increase the total cost, usually by $100 to $200 or more depending on your area.

A knowledgeable DIYer can perform the initial diagnostics, including entering diagnostics mode, pressing BAKE to cycle the relay, and checking for 120 volts at connector pins P6-1 to P6-5. However, if the control board relay has failed or the board needs replacement, working with line voltage components inside an oven carries real risk and many people prefer a qualified technician for that step. Replacing the oven temperature sensor is a more approachable repair for most DIYers.

Resetting the oven by cutting power at the breaker may temporarily clear the fault display, but it will not fix the underlying problem. If the cause is a welded relay or failed sensor, the condition will recur the next time the oven heats, especially under the high temperatures of a clean cycle. The fault should be properly diagnosed rather than simply reset.