mypros+
Model reference

Bosch SHE65T55UC/07

Dishwasher

3 documents24 error codes7 service modes

Available documentation

Service Manual

  • Bosch Dishwasher SHE65T55UC02 flashing lights error3 pg
    Covers this model
  • Bosch Dishwasher SHE65T55UC02 Service Check Routine3 pg
    Covers this model
  • Bosch Dishwasher SHE65T55UC02 GGVV6 664 440 00AA Repair Manual82 pg
    Covers this model
MyPros+ Max

Diagnose your Bosch SHE65T55UC/07.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (24)

CodeMeaning
E:00No errors stored in memory.E:01Faulty pump relay in the power module.E:02Faulty heater relay in the power module.E:05Faulty water switch relay causing water switch to run continually.E:06Door latch Hall effect sensor not detected; dishwasher won't run and Clean LED…E:08Heat pump detects low water level; dishwasher runs without heating.E:09Faulty heater circuit (open circuited) in heat pump.E:11NTC temperature sensor or NTC wiring harness error in heat pump; dishwasher not…E:12Only one NTC returns a signal; the dishwasher shuts down as a heater protection…E:13Incoming water temperature too hot (>75°C / 167°F); dishwasher runs without…E:15Float switch activated; water doesn't fill and drain pump runs continually or…E:17Faulty water softener regeneration valve; water softener doesn't regenerate.E:18Water flow rate too low.E:20Faulty heat pump motor winding; wash cycle abruptly ends with Clean/Sanitized…E:21Heat pump is blocked or clogged.E:22Water in sump detected by drain pump circuit.E:23Faulty drain pump.E:24Dishwasher won't drain; drain pump is blocked or drain hose obstructed/kinked.E:25Drain pump cover missing or not properly seated; drain pump impeller not…E:26Faulty water switch; water switch runs continually.E:27Under-voltage condition; low supply voltage to dishwasher.E:28Aqua sensor not properly calibrated; aqua sensor doesn't run during wash cycle.E:29Under/overvoltage condition; low or high supply voltage.E:30Over-voltage condition; high supply voltage to dishwasher.

Service modes (7)

  • Customer Service Program1
  • Customer service test program (P1)1
  • Error code program (P0)1
  • Failure Storage1
  • Sales demo mode (P7)1. Dishwasher must be off. 2. While pressing and holding both the 'B' and 'C' buttons, press and…
  • Settings change mode1
  • Special Function Menu1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Bosch dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass