mypros+
Model reference

Fisher & Paykel DG62T27C

Dryer

2 documents25 error codes8 service modes

Available documentation

Service Manual

  • Gas & Electric Dryers Service Summary5 pg
    Covers this model
  • INTUITIVE & AEROSMART DISPLAY MODULE - Gas & Electric Dryers Service Summary5 pg
    Covers this model
MyPros+ Max

Diagnose your Fisher & Paykel DG62T27C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (25)

CodeMeaning
1Communications failure between the sensor module and motor control module.1024 Volt supply measurement error105Communications failure between the sensor module and display module (Intuitive…11Lid lock open circuit.12Lid lock switching device failure.14Sensor module fault.15Sensor module fault.16Airflow restriction (user warning).2Drum gap cannot be located.20Door actuator stalled.21Door actuator required excess voltage.22Door actuator open circuit.23Door actuator movement interrupted by low voltage (brown out).24Door actuator movement took too long.28Data retrieval error following loss of power.29Brown-out data retrieval error.3Drum stalled.30Lid lock unable to lock (user warning)4Invalid option link read45Display Module ROM Check Error6Door jammed7Motor current excessive.7BDisplay Module RAM Check Error8Exhaust sensor over temperature9Exhaust sensor under temperature

Service modes (8)

  • Diagnostic Mode A (AeroSmart LCD)["Ensure power supply to the machine is switched on.","Press and hold the Wrinkle Free button, then…
  • Diagnostic Mode A (AeroSmart LED) – Conductivity Impedance Check["Enter the diagnostic mode (AeroSmart LED).","Press the Time Dry button five times."]
  • Diagnostic Mode A (AeroSmart LED) – Last Fault Option["Press and hold the WRINKLE FREE button (button A) and the POWER button (button B).","The dryer is…
  • Diagnostic Mode A (LED) – Conductivity Impedance Check["Enter diagnostic mode (AeroSmart LED).","Press the Time Dry button five times."]
  • Diagnostic Mode G – Conductivity Impedance Check["Enter diagnostic mode (General).","Press the Auto Dry up button five times."]
  • Diagnostic Mode G (General) – Last Fault Option["Turn the power supply to the dryer on.","Press and hold the Wrinkle Free down button, while…
  • Diagnostic Mode I (Intuitive)["Ensure power supply to the machine is switched on.","Press and hold the Lifecycles button, then…
  • Diagnostic Mode I and A (LCD) – Conductivity Impedance Check["Enter diagnostic mode for Intuitive or AeroSmart LCD.","Navigate to the Machine Status…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel dryer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax