Model reference

KitchenAid KDTM354DSS4

Dishwasher

9 documents25 error codes4 service modes

Available documentation

Service Manual

2015 Microfiltration Dishwashers with Advanced ProDry™122 pg
Covers this model
Dimension Guide2 pg
Covers this model

Tech Sheet

Tech Sheet W1075090712 pg
Covers this model
Fiche technique W10750908B16 pg
Covers this model

Bulletin

Service Pointer - W10914584C - Under-Counter Dishwasher - Door Not Sealing Properly/Leak Potential3 pg
Covers this model

Service Flash

Technical Service Pointer - W10841713 (Door Clicking)6 pg
Covers this model

Tech Tip

Instruction Sheet2 pg
Covers this model

Installation Guide

Instruction Sheet2 pg
Covers this model
Installation Instructions76 pg
Covers this model

MyPros+ Max

Diagnose your KitchenAid KDTM354DSS4.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·KitchenAid Dishwasher

1-1 on my KitchenAid KDTM354DSS4

M+

Control detected K2 pilot relay stuck

From Tech Sheet W15417694, p.26:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (25)

CodeMeaning

1-1Control detected K2 pilot relay stuck closed.1-2Damaged or corrupted memory on control board, or incompatible software…10-1Dispenser electrical problem 10-3Drying fan error 2-1Control detected stuck key(s) in keypad or keypad connection.3-1Open connector or component in Temperature Sensing circuit; open or faulty…3-2Shorted connection or component in Temperature Sensing circuit; incoming water…3-3OWI calibration failure.4-3Wash motor not running due to loose connection in Motor circuit and/or faulty…5-1Door stuck open 5-2Door stuck closed 6-1Low/no water 6-2Fill valve electrical problem 6-3Suds/air in pump 6-4Float switch open 6-7Disconnected or damaged flowmeter.6-8Regen valve electrical problem 7-1No heat 7-2Heater stuck on 8-1Slow drain 8-2Drain motor electrical problem 8-5Drain stuck on 9-1Diverter can't find position 9-2Diverter stuck on 9-3Diverter disk missing

Service modes (4)

Clear Customer Error History["Enter Service Diagnostics Cycle.","Advance to interval 21.","Press HI TEMP key to clear errors."]
Customer Cycle Rapid Advance["Start a customer cycle.","Press HIGH TEMP
Rapid Advance Mode (Customer Cycles)After starting a customer cycle, press HIGH TEMP
Service Diagnostics Cycle["Press Start key to wake up the control panel.","Press any 3 keys in the sequence…

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass