mypros+
Model reference

KitchenAid KUDC10FXWH5

Dishwasher

12 documents25 error codes3 service modes

Available documentation

Tech Sheet

  • tech sheet w10321879 revc fr2 pg
    Covers this model
  • MDB7759AS1 techsheet w10321878 revc mdb7759aws2 pdf2 pg
    Covers this model
  • Kitchnaid Dishwasher KUDC10FXSS0 KUDC10FXSS1 KUDC10FXSS2 KUDC10FXSS3 Tech Sheet2 pg
    Covers this model
  • Kitchenaid Dishwasher KUDC10IXWH6 Tech Sheet2 pg
    Covers this model

Service Flash

  • ProDry™ (with Fan Assist Operation) vs. non Fan Assist Models9 pg
    Covers this model
  • Technical Service Pointer - Upper Rack Wheel & Mount Assembly9 pg
    Covers this model
  • Service Pointer - W10460581 (Moisture Detected Inside Door Panels)2 pg
    Covers this model

Tech Tip

  • Instruction Sheet2 pg
    Covers this model
  • Installation Instructions6 pg
    Covers this model

Installation Guide

  • Installation Instructions Undercounter Dishwasher56 pg
    Covers this model
  • Instruction Sheet1 pg
    Covers this model
  • Instruction Sheet for Heater Element kit2 pg
    Covers this model
MyPros+ Max

Diagnose your KitchenAid KUDC10FXWH5.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
1-1Control detected K2 pilot relay stuck closed.1-2Control software issue10-1Dispenser electrical problem10-2Vent wax motor electrical problem10-3Drying fan error2-1Control detected stuck key(s) in keypad or keypad connection.2-2Damaged or corrupted memory on control board or incompatible software…3-1Thermistor/OWI open3-2Thermistor/OWI shorted3-3OWI failed calibration.4-3Wash motor not running5-1Door switch stuck open5-2Door switch stuck closed6-1Inlet water low/no water mechanical problem6-2Fill valve electrical problem6-3Suds/air in pump6-4Float switch open6-6Incoming water too cold (under 84°F/29°C).6-7Flowmeter problem6-8Water softener regeneration valve electrical problem7-1No heat7-2Heater stuck on8-1Slow drain8-2Drain motor electrical problem8-3Drain stuck on

Service modes (3)

  • Rapid Advance Mode (Cycle Operation)After starting a cycle (door open or closed), press Hi Temp
  • Rapid Advance Mode (within Service Diagnostics)While in Service Diagnostics Cycle, press HI TEMP
  • Service Diagnostics Cycle1

Full entry steps, exit procedures, and test sequences are available in Max.

Related KitchenAid dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass