mypros+
Model reference

Maytag MVW18MNBWW0

Washer

4 documents22 error codes10 service modes

Available documentation

Tech Sheet

  • tech sheet W10714948 RevC40 pg
    Covers this model
  • Tech Sheet - W10714948 - Rev C40 pg
    Covers this model

Quick Reference

  • Quick Reference Manual4 pg
    Covers this model

Installation Guide

  • Instrucciones de instalacion18 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag MVW18MNBWW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
F0E2Over suds condition detectedF0E4High water temperature detected during rinse cycle (105°F / 41°C or higher).F0E5Off balance load detected.F1E1Main control fault.F1E2Motor control faultF2E1Stuck keyF2E3Mismatch of main control and user interfaceF3E1Pressure sensor faultF3E2Inlet water temperature faultF5E1Lid switch faultF5E2Lid lock faultF5E3Lid unlock faultF5E4Lid not opened between cyclesF7E1Basket speed sensor faultF7E5Shifter faultF7E6Motor faultF7E7Motor unable to reach target RPMF8E1Long fillF8E3Overflow conditionF8E5Hot and cold water supply hoses are reversed.F8E6No fillF9E1Long drain

Service modes (10)

  • Calibration Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the Rinse LED is…
  • Clean Washer Cycle["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Sensing Load, Soak/Wash…
  • Drain & Spin Cycle["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Rinse and Done LEDs are…
  • Fault Code Display Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the Done LED is…
  • Manual Overview Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Final Spin and Done LEDs…
  • Quick Overview Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until only the Final Spin LED…
  • Service Diagnostic Test Modes (Entry)["Ensure washer is in standby mode (plugged in with all indicators off).","Place cycle selector…
  • Software Version Display Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Rinse, Final Spin, and…
  • Tachometer Verification Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Soak/Wash and Done LEDs…
  • UI Test Mode["Enter Service Diagnostic Test Modes.","Toggle cycle selector knob until Rinse and Final Spin LEDs…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass