Model reference
Samsung WA45H7200AW/A2-00
Washer
2 documents20 error codes10 service modes
Available documentation
Service Manual
- WASHING MACHINE Technical Information60 pg
Bulletin
- SERVICE BULLETIN - Top Loader Unbalanced During Spin Cycle1 pg
MyPros+ Max
Diagnose your Samsung WA45H7200AW/A2-00.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (20)
CodeMeaning
1EWater Level Sensor Trouble; the input signal from the water level sensor is out…3EMICOM is attempting to drive the motor but is not getting any response signals…4EFilling continues for more than 60 minutes or there is no change of water level…4E2The hot/cold water hose connection is not correct.5EThe water level fails to drop below the Reset Water Level within 30 minutes.8EMEMS communication error or MEMS trouble diagnosis error.8E1MEMS communication error or MEMS trouble diagnosis error.8E2MEMS communication error or MEMS trouble diagnosis error.AECommunication error between SUB PBA and MAIN PBA.bE2A button except the Power button is continually pressed.dEDoor is detected as open while it is trying to lock the door.dE1Door fails to unlock after 7 attempts.LEA water level lower than the Reset water level is detected for 5 seconds during…OEWater level sensor fault detected; data (frequency) shows water level is at or…PEClutch Motor Error; the position of the clutch is not detected after 3…PE1Clutch hall sensor error; after clutch position detection, the clutch hall…SdSuds is detected during the washing session; not a true error, End and SUd/Sd…SUdSuds is detected during the washing session; not a true error, End and SUd/Sd…tEWater temperature sensor fault is detected continuously for 5 seconds.UEUnbalance or cabinet bump is detected during final spin.Service modes (10)
- Board Input Test Mode["Activate Service Mode first.","Press the Self Clean Key."]
- Continuous Run Mode["Press Delay End + Temp
- Cycle Count Check Mode["Activate Service Mode first.","Press the Pre Soak Key."]
- Demo Mode["Press Pre Soak + Self Clean buttons simultaneously for 5 seconds in the power on state while a…
- Diagnostic Code Check Mode["Activate Service Mode first.","Press the Spin Key
- Fast Time Down Test Mode["Activate Service Mode first.","Press the Temp
- Quick Spin Test Mode["Enter Service Mode first.","Press Delay End and Self Clean Key for 3 seconds."]
- Quick Test Mode["Plug in the unit.","Press Spin key, Soil Level key, and Power Key at the same time."]
- S/W Version Check Mode["Activate Service Mode first.","Press the Soil Level Key."]
- Service Mode["Washer must be on.","Press Delay End and Pre Soak Key for 3 seconds or until the unit sends out…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass