mypros+
Model reference

Samsung WF448AAWXAA

Washer

5 documents14 error codes11 service modes

Available documentation

Service Manual

  • Washing Machine Drum Type Service Manual3 pg
    Covers this model
  • Washing Machine Drum Type Service Manual3 pg
    Covers this model
  • Washing Machine Drum Type Service Manual3 pg
    Covers this model
  • Washing Machine Drum Type Service Manual45 pg
    Covers this model

Other

  • SamsungTechTalkHAaugust09 part 1 page 31 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung WF448AAWXAA.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (14)

CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EMICOM is attempting to drive the motor but is not getting any response signals…7ESilver Care Kit (PCB) Failure.AECommunication error between SUB PBA and MAIN PBA.dsDoor is detected as open while it is trying to lock the door.HrHeater Relay Failure (No Heater Relay Check Signal).ndThe water level fails to drop below the Reset Water Level within 15 minutes…nF1The hot/cold water hose connection is not correct.SF1System Error.SF2System Error.SF3System Error.SrSystem Relay (Main Relay) FailuresudsSuds is detected during the washing session; not a true error but displays…tEAbnormal high/low temperature or resistance (Thermal sensor or PBA resistance).

Service modes (11)

  • Board Input Test Mode["Activate Service Mode first.","Press My Cycle (or Pure Cycle or Steam) key during Service Mode."]
  • Continuous Run Mode["Unit must be in Power On State (Normal User Mode).","Press Delay Start Key and Extra Rinse Key…
  • Cycle Count Check Mode["Activate Service Mode in advance.","Press Signal Key during Service Mode."]
  • Demo Mode["Unit must be in Power On State (Normal User Mode), cycle not running.","Press and hold Delay…
  • Diagnostic Code Check Mode["Activate Service Mode first.","Press Extra Rinse key during Service Mode to enter with code 'd'…
  • EEPROM Clear Mode["The unit needs to be on.","Press Delay Start Key, Signal Key, and Power Key at the same time."]
  • Fast Time Down Test Mode["Activate Service Mode in advance.","Press Temp key during Service Mode to enter.","Press Temp key…
  • Quick Spin Test Mode["Enter Service Mode first.","During Service Mode, press the Delay Start and My Cycle (or Pure…
  • Quick Test Mode["Plug in the unit.","Press Soil Key, Signal Key, and Power Key at the same time."]
  • S/W Version Check Mode["Activate Service Mode in advance.","Press Soil Level Key during Service Mode."]
  • Service Mode["The washer must be on.","Press Signal and Extra Rinse Keys for 3 seconds or until the unit sends…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass