Model reference

Whirlpool YKESA907PC00

Range

5 documents30 error codes1 service mode

Available documentation

Tech Sheet

Tech Sheet - 976107512 pg
Covers this model
TECH SHEET - YKERA807PS00 KA Range12 pg
Covers this model

Service Flash

Service Pointer - Oven Temperature Calibration1 pg
Covers this model
Service Pointer - 8178524 (Oven Temperatures)1 pg
Covers this model

Tech Tip

hangtag-9759093-reva.pdf1 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool YKESA907PC00.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F0 E0 on my Whirlpool YKESA907PC00

M+

No failure (default state).

From Tech Sheet W13652479, p.51:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (30)

CodeMeaning

F0 E0No failure (default state).F1 E0Internal error (display board related).F1 E1Internal error (display board related).F1 E2Internal error (display board related).F1 E3Internal error (display board related).F1 E4Internal error (display board related).F1 E5Internal error (power board related).F1 E6Internal error (power board related).F1 E7Internal error (power board related).F1 E8Internal error (power board related).F1 E9Internal error (display board related).F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnect or keypad disconnected.F3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom oven sensor open).F3 E5Bottom oven sensor shorted (lower/bottom oven sensor shorted).F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F4 E2Over temperature during cook mode (temperature runaway).F4 E3Over temperature during clean mode (temperature runaway).F4 E7Over temperature cavity 2 (temperature runaway error).F5 E0Door latch mismatch F5 E1No operating latch or latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door error F6 E4Lost communication between display board and power board.F6 E5Cancel key error.

Service modes (1)

Diagnostics mode["Press the Cancel key to place the range in an idle state (if error code is not…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass