Whirlpool CHW9050AW0

Available documentation

Error codes (21)

Service modes (21)

• Code Display Mode["Washer must be in error state.","9050 Models
• Cycle Credit (Free Cycle)["Enter diagnostic mode (entire display flashing).","Press the HOT button (CC will display)."]
• Diagnostic Mode (Blink Mode)["Enter Setup/Programming mode first.","Press and hold the COLD button for 2 seconds when setup…
• Flashing Mode["9050 Models
• Help Mode["Enter Setup/Programming mode.","Press WARM button until setup code 2.XX is displayed.","Press HOT…
• Help Mode (DA Communication Established)["Open the service door.","The message dAS will appear in the display.","Press the HOT button to…
• Help Mode (dAS mode)["Enter set-up mode.","The message dAS will appear in the display.","Press the HOT button.","Press…
• Help Mode (Manual Communication)["Open the service door.","Press the WARM button until the set-up code 2.XX is displayed.","Press…
• Manual Overview Test["Enter diagnostic mode (entire display flashing).","Press the COTTON/WHITES button."]
• Quick Overview Test["Enter diagnostic mode (entire display flashing).","Press the WARM button."]
• Quick Spin Cycle["Enter diagnostic mode (entire display flashing).","Press the PERM PRESS button."]
• Service Access Code["Press the upper left button.","Press the lower right button.","Press the upper right…
• Service Access Code Entry["Door must be open if washer is not in fault mode.","Press the upper left button.","Press the…
• Set-Up Mode (9050 Models)["Insert access door key, turn, and lift to remove access door.","Use HOT button to adjust values…
• Set-Up Mode (9060 Models)["Insert a set-up card into the card slot, OR unplug washer or disconnect power.","If no set-up card
• Setup/Programming Mode (Model 9050)["Insert key into access door, turn and lift to remove the access door."]
• Setup/Programming Mode (Model 9060 via connector)["Disconnect power from the washer.","Open the console and disconnect connector AA1.","Close the…
• Washer Cleanout Cycle["Enter diagnostic mode (entire display flashing).","Press the COLORS/DELICATES button."]
• Washer Diagnostic Mode["First enter Set-Up Mode (see Set-Up Mode entry procedures).","Press and hold the COLD button for…
• Washer Diagnostic Mode (via Key Dance - 9060 non-coin models with $0 vend price)["Key dance must be performed within 60 seconds.","Press Cottons/Whites button.","Press Cold…
• Washer Diagnostic Mode (via Service Access Door)["Open the service access door on top of the metercase (9050 models

Full entry steps, exit procedures, and test sequences are available in Max.