Model reference

Whirlpool GHW9160PW0

Washer

2 documents16 error codes4 service modes

Available documentation

Tech Sheet

Whirlpool Washer Tech Sheet GHW9150PW416 pg
Covers this model

Installation Guide

Instruction Sheet2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GHW9160PW0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

F/01 on my Whirlpool GHW9160PW0

M+

No water entering machine detected

From Tech Sheet W10738819, p.31:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (16)

CodeMeaning

F/01No water entering machine detected within 30 seconds (valves turned off) OR…F/02Drain time exceeds eight minutes; water valves are turned off.F/05Water temperature sensor (NTC) value is out of range during water heating step…F/06Drive motor tachometer error; control is unable to properly detect motor speed…F/07Motor Control Unit (MCU) error; main control has detected a short in the MCU.F/09Overflow condition; overflow contact on pressure switch is closed for more than…F/10MCU heat sink thermal protector has tripped due to overheating, stopping motor…F/11Serial communication error between the Central Control Unit (CCU) and the Motor…F/13Dispenser system error; dispenser motor cannot be driven to its proper position.F/14EEPROM error; error reading data from the EEPROM onboard the CCU.F/15Motor Control Unit (MCU) error; MCU detects multiple resets or errors during a…F/21System leak; no water entry detected within 30 seconds or flow sensor detected…F/dlCCU/touch-pad/LED communication error; touch-pad/LED assembly is not able to…F/dUDoor lock error; door cannot be locked after six attempts.FHPressure switch failure; no water entering machine detected within 30 seconds…SudSuds lock condition detected by MCU analyzing current draw on drive motor; may…

Service modes (4)

Diagnostic Test Mode1
Last Stored Failure Code Recall1
Washer Monthly Maintenance/Cleaning Cycle (Kenmore Elite HE)1
Washer Monthly Maintenance/Cleaning Cycle (Whirlpool Duet)1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass