Error code reference

Amana Dryer Error Code dSFL

Fault detected in the microprocessor temperature sensor circuit; buzzer will sound approximately 5 seconds every 30 seconds until the problem is corrected or power is discontinued.

SourceAmana Microwave - ADC AD-75THS ServiceManual-PH5 PastProduction OPL: RCC-10Section VI-F, page 62

Diagnostic procedure

The full dSFL procedure

Step 1 is visible so you can confirm you are on the right page. The remaining steps, the ones that tell you whether to actually replace a part, unlock with any pass.

MyPros+ · DiagnosticsStep 1 preview
1
First diagnostic step
Check if the 1/8-Amp (Slo Blo) fuse on the back side of the microprocessor controller has blown; if blown, replace fuse (ADC P/N: 136048) - do not replace the entire controller.

SourceAmana Microwave - ADC AD-75THS ServiceManual-PH5 PastProduction OPL: RCC-10Section VI-F, page 62

More steps, wiring diagram references, and verified part numbers
Includes expected resistance and voltage values, connector pinouts, and supersession notes for replacement parts.
Unlock dSFL procedure $9.95

Or subscribe: $29/month for all codes plus Max diagnostics, with 70 Max messages a day. Plus applicable tax.

Where this code is documented

8 manuals in the MyPros+ library document this code for Amana dryer.

Models covered by the manuals that document this code

More models are covered than are listed here.

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax