Skip to main content
Error code reference
Electrolux Ice Maker Error Codes
19 error codes documented with diagnostic procedures.
Have your model number? Get codes specific to your unit.
2Mold Motor test errorE1Thermistor 1 is open.E10Door #2 (drawer) open longer than 20 minutesE11EE Memory error.E2Thermistor 1 is shorted.E3Main door or bottom drawer is open longer than 20 minutesE4Compressor has 100% runtime between two defrost cycles. Does not show on displayE5Thermistor 1 out of range +10°F for more than 12 hours (actual temp over setpoint by 10…E6Thermistor 1 out of range -10°F for more than 12 hours (actual temp under setpoint by 10…E7Thermistor 2 open or shorted.E8Thermistor 3 open or shorted.E9Thermistor 4 open or shorted.ErBail Arm Switch test errorOPOpen Mold Thermistor detected during Ice Maker diagnostic test 56C.P1Pump circuit open due to high water level in ice bin, detecting a drain problemRAPID_FLASHLED rapid flashing indicates the control board is receiving a high heat signal from the…SHShorted Mold Thermistor detected during Ice Maker diagnostic test 56C.SLOW_FLASHLED slow flash indicates the control board has detected a sensor problem (thermistor plug…STEADYLED steady light indicates the control board has power and operation is normal.
Get the full diagnostic procedure for any code
Step-by-step tests, expected values, wiring diagram references, and verified part numbers.
Get Started $9.95 3-day pass$29/month for all brands and Max diagnostics, with 70 Max messages a day. Plus applicable tax.