Maytag Oven Error Code C-82

C-82 indicates an over-temperature condition on the induction cooktop, classified as a Type 2 failure. This means the induction system overheated specifically because of inadequate ventilation rather than a failed component. The appliance has shut down as a safety precaution to protect the internal electronics. Addressing the airflow or installation issue is required to clear the error and return the unit to normal operation.

No, you should not continue using the induction cooktop while C-82 is active. The error means internal components have reached an unsafe temperature, and continuing to operate the unit risks damage to the inverter boards or other electronics. Allow the unit to cool completely and resolve the ventilation issue before attempting to use it again.

If the fix is simply clearing blocked vents or adjusting the installation clearances, there may be little to no cost beyond your time. If a cooling blower motor has failed and needs replacement, repair costs including parts and labor typically range from $100 to $300 depending on your location and the service provider. Inverter board damage caused by repeated overheating events can push repair costs considerably higher, so addressing the ventilation issue promptly is important.

Start by reviewing your installation against the Installation Instructions that came with the appliance, focusing on required clearances and the condition of the blower intakes. Clear any debris, grease, or obstructions from the intake vents and confirm the unit has adequate space on all sides and at the rear. If the installation checks out and the error persists, the internal cooling blower may need to be inspected or replaced by a qualified technician.

A power reset may temporarily clear the C-82 code, but the error will return if the underlying ventilation problem is not corrected. Simply resetting without fixing the airflow issue means the induction system will overheat again during use. The root cause, whether blocked intakes, insufficient clearance, or a failing blower, must be addressed for the repair to hold.