Maytag Oven Error Code F-1

The F-1 code on a Maytag oven indicates a fault in the electronic control system. On Type A clock ovens, the electronic control board is suspected. On Type B clock ovens, the clock assembly itself is the suspect component. In both cases, the fault originates internally within the control or clock unit rather than in an external sensor or wiring harness.

It is not advisable to continue using the oven while the F-1 code is active. The fault indicates the control system is not operating correctly, which means the oven may not regulate temperature accurately or respond to user commands as expected. Disconnect the appliance from power until the fault is diagnosed and the defective component is replaced.

Repair costs vary depending on whether the electronic control board or the clock assembly needs replacement, as well as labor rates in your area. Parts for control boards and clock assemblies on Maytag ovens generally range from around 100 dollars to 300 dollars or more, and professional labor can add another 75 to 200 dollars depending on the service provider. Getting a diagnostic visit from a certified technician is recommended before purchasing parts.

Pressing the CANCEL button is the recommended first step and may clear the code if the fault was caused by a transient power issue. If the F-1 code returns after pressing CANCEL, you should disconnect the oven from power completely and then restore power. If the code reappears again after that, a reset will not resolve the issue and the control board or clock assembly likely needs replacement.

Start by pressing the CANCEL button, then disconnect the oven from power for several minutes before restoring it. If the F-1 code comes back, identify whether your oven uses a Type A or Type B clock configuration, as this determines whether you need to replace the electronic control board or the clock assembly. Replacement of the faulty control component is the typical resolution for a persistent F-1 fault.