Maytag Oven Error Code F-6

F-6 on a Maytag oven indicates a suspected fault within the electronic control board, which is the main circuit board that manages all oven functions. The board has detected an internal error it cannot resolve on its own. This code directs attention to the control board itself rather than to external components like sensors or heating elements.

A reset by pressing CANCEL followed by a full power disconnection may clear the code if the cause was a temporary glitch in the board's memory. However, if F-6 reappears after power is restored, the reset will not provide a lasting fix. A recurring F-6 code points to a hardware failure that requires board replacement.

The cost depends on whether the repair involves only a control board replacement or additional labor and parts. A replacement electronic control board for a Maytag oven typically costs in the range of $150 to $350 for the part alone, with professional labor adding $100 to $200 or more depending on the service provider. Obtaining a repair estimate before proceeding is advisable to compare against the cost of a new appliance.

You can start by pressing the CANCEL button and then fully disconnecting the oven from power for several minutes to allow a complete reset. If the code returns when power is restored, the electronic control board most likely needs to be replaced. Replacing the control board is a moderate-difficulty repair that requires safely accessing the back or top panel of the oven and disconnecting multiple wire harnesses.

It is not recommended to continue using the oven while the F-6 fault code is active. Because the error implicates the control board, the board may not properly regulate temperature or manage safety shutoffs during a cooking cycle. Disconnect the oven from power until the issue is diagnosed and resolved.