Model reference
Amana YY-100-AA
Furnace
5 documents34 error codes7 service modes
Available documentation
Tech Sheet
- Tech Sheet24 pg
- tech sheet w11482160 reva24 pg
Tech Tip
- Control Guide38 pg
Installation Guide
- Instrucciones de instalacion18 pg
- Instrucciones de instalacion18 pg
MyPros+ Max
Diagnose your Amana YY-100-AA.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (34)
CodeMeaning
F0E0No error(s) found (default).F1E0Check oven user interfaceF1E1Check oven appliance managerF1E4ACU PCBA failure (stuck key failure).F2E0Keypad disconnected.F2E1Stuck key failure on touch panel.F3E030" (76.2 cm) oven sensor open or shorted.F3E118" (45.7 cm) oven sensor open or shorted.F3E2Warming drawer sensor shorted (range not equipped with this feature).F3E3Meat probe shorted.F4E1Cavity temperature sensor failure.F4E4Humidity sensor error.F4E9Popcorn error (popcorn sensor failure).F5E0Door and latch switch do not agree.F5E1Door latch not operating.F6E0Lost communication between user interface and appliance manager.F6E1Cook oven over temperature.F6E2Clean oven over temperature.F6E4User interface / appliance manager mismatch.F6E5No cavity size command.F7E0Water is not high enough or water did not boil fast enough.F7E1Boiler over temperature.F7E2Boiler NTC out of range.F7E3Improper filter reset.F7E4Conductivity sensor not connected.F8E0Right blower low speed too low.F8E2Right blower high speed too low.F8E4Left blower low speed too high.F8E5Exhaust air template detector failure (HF NTC thermistor failure).F8E6Left blower high speed too high.Service modes (7)
- Diagnostic / Test Mode["Plug in microwave oven or reconnect power.","Press the Cancel keypad to reach standby (display…
- Diagnostics / Test Mode["Plug in microwave oven or reconnect power and press the Cancel keypad to standby (\":\").","Close…
- Diagnostics Mode["Plug in microwave oven or reconnect power.","Press CANCEL button to reach standby display…
- Diagnostics Mode - Extended Mode["Press OFF","Press OFF","Press START"]
- Diagnostics Mode - Key Functions["Enter Diagnostics Mode (CANCEL
- Diagnostics Mode / Self-Diagnostic Test Mode["Plug in microwave oven or reconnect power.","Press CANCEL to go to standby (':' on…
- Touch Panel and ACU PCBA Test (Diagnostics Mode)["Plug in microwave oven or reconnect power and press Cancel button to Standby (':').","Close door…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Amana furnace models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass