Model reference

Bosch SHP865WF2N/01

Dishwasher

1 document24 error codes3 service modes

Available documentation

Service Manual

Repair Instructions – Bosch Dishwasher Manual132 pg
Covers this model

MyPros+ Max

Diagnose your Bosch SHP865WF2N/01.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Bosch Dishwasher

E:01 on my Bosch SHP865WF2N/01

M+

Faulty pump relay on power module, or

From Service Manual 913444, p.16:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drain pump winding resistance at connector J7. Expected: 12 to 16 ohms at room temperature.

3.Verify the board switches the pump at 120 VAC during the drain cycle.

Part 00620774

Drain pump

Error codes (24)

CodeMeaning

E:01Faulty pump relay on power module, or low voltage/excessive voltage drop, or…E:02Faulty heater relay on power module.E:04Faulty safety heater relay or faulty heater.E:05Faulty water switch relay; dishwasher will drain and wash cycle will finish.E:06Door ajar, not properly latched, or door latch Hall sensor not detected.E:08Heat pump detects low water level; dishwasher runs without heating because both…E:09Faulty heater circuit (open-circuited).E:11Heat pump NTC resistances out of range or NTC's show different values.E:13Incoming water too hot (> 75°C / 167°F)E:15Water in base activated float switch; dishwasher can't be shut off.E:17Inlet water flow rate too high.E:18Inlet water flow rate too low; dishwasher waits for water filling then wash…E:20Faulty heat pump wire harness or faulty heat pump motor winding.E:21Heat pump is blocked or clogged.E:22Water in sump; dirty fine filter screen or coarse multi-filter.E:23Faulty drain pump wire harness or faulty drain pump.E:24Drain obstruction E:25Drain pump blocked or drain pump cover not properly seated/locked into position.E:26Faulty water switch harness or faulty water switch/water switch motor E:27Low supply voltage (< 85 VAC).E:28Aqua sensor not properly calibrated E:29Low supply voltage (< 85 VAC)E:30High supply voltage (> 140 VAC)E:32Overloaded drain pump

Service modes (3)

Customer service error code programRun the customer service test program to check error codes
Customer settings (codings) mode1. Press On/Off to turn the dishwasher on. 2. While pressing and holding button '1', press and hold…
Reset power module1. With door closed and dishwasher turned on, press and hold Start for five (5) seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Bosch dishwasher models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass