mypros+
Model reference

Frigidaire GLTF2940ES3

Washer

4 documents36 error codes3 service modes

Available documentation

Tech Sheet

  • Washer Tech Data Sheet12 pg
    Covers this model

Service Manual

  • Front-Load Washing Machine Service Manual8 pg
    Covers this model

Service Flash

  • Change to Shipping Restraint System on Front-Load Washer Models2 pg
    Covers this model

Other

  • TUMBLE ACTION WASHER Use & Care Guide9 pg
    Covers this model
MyPros+ Max

Diagnose your Frigidaire GLTF2940ES3.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (36)

CodeMeaning
E11Fill time too long.E13Water leak in tub or air leak in air bell.E21Water not pumping out fast enough.E23Drain pump relay on control board failed.E24Drain pump relay on control board failed.E31Better modelsE35Better modelsE41Control board thinks the door switch is open.E42Door remains locked after cycle is completed.E43Control board problem.E44Control board problem.E45Control board problem.E46Control board problem.E47Board thinks the door PTC circuit is open in spin.E48Board thinks the door PTC circuit is closed.E52Bad signal from tacho generator.E55Motor overheating.E56High motor current.E57High current on inverter.E58High current on motor phase.E59No tacho signal for 3 seconds.E5AHigh temperature on heat sink.E5BHigh temperature on heat sink.E5CHigh temperature on heat sink.E5DCommunication problem.E5ECommunication problem.E5FCommunication problem.E67Input voltage on microprocessor incorrect.E75Better models onlyE76Better model only
View all 36 error codes
E95Communication error.EB1Incoming power frequency out of limits.EB2Incoming line voltage above 130 VAC.EB3Incoming line voltage below 90 VAC.EF1Clogged drain pump.EF2Too much soap.

Service modes (3)

  • Clear Stored Error Code["Place the control into Diagnostic Test Mode.","Turn the program knob clockwise 9 clicks from the…
  • Diagnostic Test["On non-digital display models, turn the Program Knob to start position, Drain/Spin
  • Error Code Recall["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the Start and Pause…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Frigidaire washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass