Model reference

Whirlpool GERC4120PT1

Range

1 document30 error codes1 service mode

Available documentation

Tech Sheet

TECH SHEET - 9758015 - Rev E12 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool GERC4120PT1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F0 E0 on my Whirlpool GERC4120PT1

M+

No failure (default code).

From Tech Sheet W10498454, p.26:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (30)

CodeMeaning

F0 E0No failure (default code).F1 E0Internal error (display board related).F1 E1Internal error (display board related).F1 E2Internal error (display board related).F1 E3Internal error (display board related).F1 E4Internal error (display board related).F1 E5Internal error (power board related).F1 E6Internal error (power board related).F1 E7Internal error (power board related).F1 E8Internal error (power board related).F1 E9Internal error (display board related).F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnect or keypad disconnected.F3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom/lower oven sensor open).F3 E5Lower/bottom oven sensor shorted.F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F4 E2Over temperature during cook mode (temperature runaway in cook).F4 E3Over temperature during clean mode (temperature runaway in clean).F4 E7Over temperature cavity 2 (temperature runaway error in second cavity).F5 E0Door latch mismatch F5 E1No operating latch or latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door error F6 E4Lost communication between display board and power board.F6 E5Cancel key error.

Service modes (1)

Diagnostic mode["Press the Cancel key to place the range in an idle state.","Press the Cancel and Start keys in…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass