Model reference

Whirlpool WERC3100PQ1

Range

1 document30 error codes2 service modes

Available documentation

Tech Sheet

Tech Sheet - 9758014 - Rev B12 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WERC3100PQ1.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F0 E0 on my Whirlpool WERC3100PQ1

M+

No failure (default state).

From Tech Sheet W11696966, p.18:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (30)

CodeMeaning

F0 E0No failure (default state).F1 E0Internal error on display board.F1 E1Internal error on display board.F1 E2Internal error on display board.F1 E3Internal error on display board.F1 E4Internal error on display board.F1 E5Internal error on power board.F1 E6Internal error on power board.F1 E7Internal error on power board.F1 E8Internal error on power board.F1 E9Internal error on display board.F2 E0Stuck key (shorted key) on keypad.F2 E1Keypad disconnected.F3 E0Main oven sensor open (top oven sensor opened).F3 E1Main oven sensor shorted (top oven sensor shorted).F3 E2Meat probe shorted.F3 E4Bottom oven sensor open (bottom/lower oven sensor open).F3 E5Lower/bottom oven sensor shorted.F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F4 E2Over temperature during cook mode (temperature runaway).F4 E3Over temperature during clean mode (temperature runaway).F4 E7Over temperature cavity 2 (temperature runaway error).F5 E0Door latch mismatch F5 E1No operating latch / latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E7Unlock door error F6 E4Lost communication between display board and power board.F6 E5Cancel key error.

Service modes (2)

Diagnostic mode - relay and switch testing["Press Cancel key to place the range in an idle state.","Press Cancel, Cancel, Start in that…
Diagnostic mode (error code recall)["Press Cancel key to place the range in an idle state.","Press Cancel, Cancel, Start in that…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass