Model reference

Whirlpool WFG366LVQ0

Range

8 documents32 error codes3 service modes

Available documentation

Tech Sheet

Tech Sheet - W10198615 - Rev B_W101986156 pg
Covers this model

Service Manual

Whirlpool Gas Range Direct Spark Ignition System29 pg
Covers this model
Job Aid - 30″ Freestanding Self-Cleaning Gas Range68 pg
Covers this model
30″ Freestanding Self-Cleaning Gas Range68 pg
Covers this model
Whirlpool Gas Range Direct Spark Ignition System KR-2829 pg
Covers this model

Installation Guide

Installation Instructions20 pg
Covers this model
Instruction Sheet2 pg
Covers this model
Instruction Sheet2 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WFG366LVQ0.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Range

F0 E0 on my Whirlpool WFG366LVQ0

M+

Factory default - not an error.

From Tech Sheet W11732591, p.43:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (32)

CodeMeaning

F0 E0Factory default F1 E0EEPROM communications error.F1 E1EEPROM checksum error.F1 E2UL A/D error(s).F1 E4Model ID error.F1 E6Latch signal mismatch error.F1E0Internal board failure.F1E1Internal board failure.F2 E0Shorted key.F2 E1Key tail unplugged.F2E0Shorted key (A/D error).F2E1A/D error.F2E2A/D error.F3 E0Oven sensor opened F3 E1Oven sensor shorted F3 E2Bake range over temperature.F3 E3Clean range over temperature.F3 E4Oven sensor opened F3 E5Oven sensor shorted F3 E6Warming drawer sensor open.F3 E7Warming drawer sensor shorted.F3E0Oven sensor opened.F3E1Oven sensor shorted.F3E2BAKE/BROIL range over temperature.F3E3CLEAN range over temperature.F5 E0Door switches do not agree.F5 E1Door latch not operating.F5E0Door and switches do not agree (Clean mode).F5E1Door latch not operating (Clean mode).F5E2Door and switches do not agree (Clean mode).

View all 32 error codes

F8 E0N/A (no likely failure condition described).PFA reset has occurred in the Electronic Range Control (ERC), typically caused by…

Service modes (3)

Diagnostics ModePress CANCEL 2 times and then START within a 5-second period.
Last Error Code RecallPress and hold the CANCEL/OFF key for 5 seconds until the last error code is displayed.
Temperature AdjustmentStep 1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass