mypros+
Model reference

Whirlpool W10702904C

Washer

1 document21 error codes10 service modes

Available documentation

Tech Sheet

  • Tech Sheet - W10702904 - Rev C16 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool W10702904C.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (21)

CodeMeaning
d13Coin 2 error; the Coin 2 sensor is detected as blocked for 8 seconds.d16Generation 2 debit card reader error; no communication from installed debit…d5Coin 1 error; the Coin 1 sensor is detected as blocked for 8 seconds.d9Low voltage detection error; incoming voltage detected below 90VAC for 8…F01Communication error within the Central Control Unit (CCU); the pump drive in…F11Motor Control Unit (MCU) has a failure, possibly a repeating under or…F20No water detected entering washer; the first level of the pressure switch is…F21Long drain; the drain time exceeds 8 minutes without reaching reset level in…F22Door lock error; washer makes several attempts to lock the door and fails twice…F24Temperature sensor error; water temperature sensor value is out of range (23°F…F25Tachometer error; the MCU is unable to properly detect motor speed and the…F26Door switch error; the door switch circuit is open for 5 seconds while the door…F27Overflow conditions; the overflow contact on the pressure switch is closed for…F28Communication failure between CCU and MCU.F29Door unlock error; the door is unable to unlock after 6 tries.F31Overheating of motor; the heat sink exceeds 212°F (100°C)F33Pump disconnected; the electrical connection between the pump and the CCU is…F34Load detected in washer during Washer Cleanout Cycle.F70Communication failure between CCU and UI (User Interface).F73Communication error within the User Interface, possibly caused by a power…F74Communication error within the User Interface, possibly caused by a power…

Service modes (10)

  • Code Display Mode["Open the service door when the washer is in error state.","The current F code or d code will be…
  • Cycle Credit["Enter Flashing Mode (entire display flashing).","Press the HOT button (CC will display)."]
  • Help Mode (DA Communication Established)["Open the service door.","The message dAS will appear in the display.","Press the HOT…
  • Help Mode (Manual Communication)["Open the service door.","Press the WARM button until the set-up code 2.XX is on display.","Press…
  • Manual Overview Test["Enter Flashing Mode (entire display flashing).","Press the COTTON/WHITES button to start Manual…
  • Quick Overview Test["Enter Flashing Mode (entire display flashing).","Press the WARM button to start Quick Overview…
  • Quick Spin Cycle["Enter Flashing Mode (entire display flashing).","Press the PERM PRESS button to start Quick Spin…
  • Setup Mode["Insert access door key, turn, and lift to remove access door.","Use HOT button to adjust values…
  • Washer Cleanout Cycle["Enter Flashing Mode (entire display flashing).","Press the COLORS/DELICATES button to start…
  • Washer Diagnostic Mode (Flashing Mode)["Enter Start Operating Set-Up (open service door).","Press and hold the COLD button for 2 seconds…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass