mypros+
Error code reference

GE Washer, Dryer Error Codes

26 error codes documented with diagnostic procedures.

Have your model number? Get codes specific to your unit.
1Lid lock didn't occur or lid lock signal not seen by control due to lack of connection.10Mode shift feedback monitor12Redundant flood condition13Redundant lid unlocked15Water temp sensor invalid17Dry load sense timeout18Drain pump clearing algorithm failed19UI state timeout2Control did not get lid closed signal from switch while motor was moving; switch didn't…20Critical flood level by gallons22Out of balance (OOB) during dry load sense23Critical lid lock failure24Lid logic failure25Pressure sensor dropout26Out of balance (OOB) ended final spin27Water accessibility28Options knobs feedback invalid29Suds lock abatement failure3Locked rotor monitor30Stuck button fault31Out of balance (OOB) fallback in final spin32Critical lid lock failure: can't unlock lid5Mode shifter6Critical flood level by pressure8Pressure sensor loss9Lid switch redundancy

Get the full diagnostic procedure for any code

Step-by-step tests, expected values, wiring diagram references, and verified part numbers.

Get Started $9.95 3-day pass

$29/month for unlimited access to all brands and Max AI diagnostics.

More GE error codes

Common questions

How do I find the error code on my GE Washer, Dryer?
Most GE washer, dryers show the code directly on the control panel display. If your model has no display, it can be read by entering diagnostic mode with the key sequence for your model. The full procedures include model-specific instructions for reading codes.
Are these codes specific to my model?
The codes here apply broadly to GE washer, dryers. Meanings and diagnostic steps can vary by model and production year, so enter your model number for model-specific information and procedures.
What do I do if my code is not listed?
Some codes are model-specific or only appear in diagnostic mode. Enter your model number to get codes specific to your unit, or contact us. We update the database continuously from manufacturer service documentation.
How much does it cost to access the full diagnostic procedures?
A 3-day pass is $9.95 one-time and gives full access to all brands, codes, and procedures. Monthly access is $29/month with unlimited access to everything including Max AI diagnostics.