Model reference

Fisher & Paykel RF201ADUX-22302A

Refrigerator

1 document35 error codes13 service modes

Available documentation

Service Manual

Diagnostic Manual17 pg
Covers this model

MyPros+ Max

Diagnose your Fisher & Paykel RF201ADUX-22302A.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Fisher & Paykel Refrigerator

1 on my Fisher & Paykel RF201ADUX-22302A

M+

On the last power up, the power module

From Service Manual 826029, p.41:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (35)

CodeMeaning

1On the last power up, the power module failed self test.10The resistance of the PC sensor is outside the normal range (< 660 Ohms).11The current measured for the ambient heater, PC fan and FC fan is lower than…12The current measured for the ambient heater, PC fan and FC fan is higher than…13The low ambient heater is drawing less current than expected 14The low ambient heater is drawing more current than expected 15The PC fan is drawing less current than expected 16The PC fan is drawing more current than expected 17The FC fan is drawing less current than expected 18The FC fan is drawing more current than expected 2The previous 2 defrosts were aborted after 40 minutes.20The flapper heater current is low.21The flapper heater current is high.22The resistance of the PC sensor 2 is outside the normal range (> 45K Ohms).23The resistance of the PC sensor 2 is outside the normal range (< 660 Ohms).24The resistance of the ice tray sensor is outside the normal range (> 45K Ohms).25The resistance of the ice tray sensor is outside the normal range (< 660 Ohms).26The icemaker timer has timed out; the icemaker gearbox is not returning to the…27The icemaker motor current is high.28Icemaker solenoid current high.29Icemaker solenoid current low.3The resistance of all the temperature sensors is outside the normal range (>…32Water dispenser solenoid driver 1 has failed; product reverts to solenoid…33Water dispenser solenoid driver 2 has failed; solenoid driver 1 may still be…34Both water dispenser solenoid drivers have failed.4The resistance of all the temperature sensors is outside the normal range (<…40Icemaker solenoid transistor 1 short circuit on the control module.41Icemaker solenoid transistor 2 short circuit.5The resistance of the FC sensor is outside the normal range (> 45K Ohms).6The resistance of the FC sensor is outside the normal range (< 660 Ohms).

View all 35 error codes

7The resistance of the Evaporator sensor is outside the normal range (> 45K…8The resistance of the Evaporator sensor is outside the normal range (< 660…9The resistance of the PC sensor is outside the normal range (> 45K Ohms).F30No display signal received (shorted or broken wire).F31No display signal received (shorted or broken wire) clock or data line.

Service modes (13)

Data Download ModePress and hold the MENU button, then press the UP button for 4 seconds (to enter Diagnostic mode)…
Diagnostic Mode (From January 2009, non measured fill)Press and hold the MENU button, then press the UP button and hold both for 4 seconds.
Diagnostic Mode (Pre-January 2009, with measured fill)Press and hold the MENU button, then press the UP button and hold both for 4 seconds.
Flowmeter Calibration (Pre-January 2009)Press and hold Measured Fill + Down + On/Off for 4 seconds.
Force Manual Icemaker (From January 2009)Press Lock key first, then press Down + Up keys and hold all 3 keys for 4 seconds
Forced Defrost (From January 2009)Press and hold MENU + DOWN for 4 seconds.
Input/Output Status1
Manually Force Icemaker (Pre-January 2009)Press and hold Measured Fill + Down + Up for 4 seconds
Manually Forced Defrost (Pre-January 2009)Press and hold MENU + DOWN for 4 seconds.
Sabbath Mode (From January 2009)Press and hold MENU + DOWN + Lock for 4 seconds.
Sabbath Mode (Pre-January 2009)Press and hold MENU + Measured Fill + Down + On/Off for 4 seconds.
Show Off Mode (From January 2009)Press and hold MENU + DOWN + UP for 4 seconds.
Show Off Mode (Pre-January 2009)Press and hold MENU + DOWN + UP + On/Off for 4 seconds.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Fisher & Paykel refrigerator models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass