mypros+
Model reference

GE WCVH6260FWW

Washer

2 documents33 error codes16 service modes

Available documentation

Service Manual

  • Service Test Mode7 pg
    Covers this model
  • GE Front Load Washer Technical Service Guide61 pg
    Covers this model
MyPros+ Max

Diagnose your GE WCVH6260FWW.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (33)

CodeMeaning
E22Fill timeoutE23Flood protect drainE30Drain pump not presentE31Drain timeoutE38Dispenser errorE39Dispenser timeoutE42Drive motor instantaneous excess current draw.E43DC FaultE45Drive motor overload currentE46Drive motor over temperatureE47Heat sink over temperatureE48Drive motor openE49Drive motor overload powerE4AUnder voltsE4BOver voltsE4CUnder volts DC bus (inverter).E4EUnder volts after startE4FEEPROM faultE52Main control wake-up errorE53Buffer errorE54No motor responseE57Checksum failureE58Communication failureE60Door lock switch failureE61Door unlock switch failureE62System contact failureE63Unexpected open doorE64Unexpected open door while runningE65Water level sensor failure (foam)E66Water temperature sensor open.
View all 33 error codes
E67Water temperature sensor shorted.E70Stuck keyE71Key fault

Service modes (16)

  • Control Board Programming Mode1. Reconnect power to the washer (display will show '---' meaning no model selected). 2. Rotate the…
  • Service Test Mode["Machine must be in idle mode (completed cycle). If water remains, manually drain to reset water…
  • t01 - Model ID["Enter service test mode (display shows t01).","Press Start/Pause to display model ID…
  • t02 - Error Codes["Navigate to t02 in service test mode.","Press Start/Pause to display the most recent error code…
  • t03 - Software ID["Navigate to t03 in service test mode.","Press Start/Pause to display software revision…
  • t04 - LED Illumination and Button Test["Navigate to t04 in service test mode.","Press Start/Pause to test LEDs and cycle lights
  • t05 - Pump Test["Navigate to t05 in service test mode.","Press Start/Pause
  • t06 - Pressure Switch Test["Navigate to t06 in service test mode.","Press Start/Pause
  • t07 - Thermistor/Heater Test["Navigate to t07 in service test mode.","Press Start/Pause
  • t08 - Hot Water Test["Navigate to t08 in service test mode.","Press Start/Pause
  • t09 - Cold Water Test["Navigate to t09 in service test mode.","Press Start/Pause
  • t10 - Tumble Test["Navigate to t10 in service test mode.","Press Start/Pause
  • t11 - Spin Test["Navigate to t11 in service test mode.","Press Start/Pause
  • t12 - Dispenser Test["Navigate to t12 in service test mode.","Press Start/Pause to advance.","Displays Pdt and fills…
  • t13 - EOL Test["Navigate to t13 in service test mode.","Press Start/Pause to run factory end-of-line test…
  • t14 - Spin Speed Ramp Up Test["Navigate to t14 in service test mode.","Press Start/Pause

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass