mypros+
Model reference

GE WSSH300G

Washer

2 documents32 error codes4 service modes

Available documentation

Service Manual

  • GE WASHER WSSH300G Technical Service Guide57 pg
    Covers this model
  • GE WASHER Technical Service Guide57 pg
    Covers this model
MyPros+ Max

Diagnose your GE WSSH300G.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (32)

CodeMeaning
E11Fill time too long.E13Water leak in tub or air leak in air bell.E21Water not pumping out fast enough.E23Drain pump relay on control board failed or wire off pump.E24Drain pump relay on control board failed or wire off pump.E41Control board thinks the door switch is open.E42Door remains locked after cycle is completed.E43Board communications problem.E44Board communications problem.E45Board communications problem.E46Board communications problem.E47Board thinks the door PTC circuit is open in spin.E48Board thinks the door PTC circuit is closed.E52Bad signal from tacho generator.E55Motor overheating.E56High motor current.E57High current on inverter.E58High current on motor phase.E59No tacho signal for 3 seconds.E5AHigh temperature on heat sink.E5BHigh temperature on heat sink.E5CHigh temperature on heat sink.E5DCommunication problem.E5ECommunication problem.E5FCommunication problem.E67Input voltage on microprocessor incorrect.E95Communication error.EB1Incoming power frequency out of limits.EB2Incoming line voltage above 130 VAC.EB3Incoming line voltage below 90 VAC.
View all 32 error codes
EF1Clogged drain pump.EF2Too much soap.

Service modes (4)

  • Clear Stored Error Code["Place the control in Diagnostic Test Mode.","Turn the cycles knob 9 clicks from the Start…
  • Control Lock["Press OPTIONS and SELECT at the same time until the Control Lock indicator is lighted."]
  • Diagnostic Test Mode["Turn the Cycles Knob to Spin (start position).","Press Pause/Cancel to turn off the LEDs and…
  • Error Code Recall["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the Start and Pause…

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass