mypros+
Model reference

Whirlpool GR448LXPQ3

Range

9 documents48 error codes24 service modes

Available documentation

Tech Sheet

  • TECH SHEET4 pg
    Covers this model
  • TECH SHEET - 9759784 - Rev C4 pg
    Covers this model
  • TECH SHEET - Electric Range4 pg
    Covers this model

Service Manual

  • ELECTRIC RANGE Use & Care Guide28 pg
    Covers this model
  • TECHNICAL EDUCATION JOB AID 4317368 KAC-40 FAILURE CODES AND WIRING DIAGRAMS for WHIRLPOOL AND KITCHENAID SLIDE-IN & FREESTANDING GAS & ELECTRIC RANGES80 pg
    Covers this model

Service Flash

  • Service Pointer K81785271 pg
    Covers this model
  • Service Pointer - Oven Temperature Calibration1 pg
    Covers this model
  • Service Pointer - 8178524 (Oven Temperatures)1 pg
    Covers this model

Installation Guide

  • Installation Instructions 30" (76 CM) Freestanding Electric Ranges12 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool GR448LXPQ3.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (48)

CodeMeaning
EndEnd of a timed cooking or self-cleaning cycle; the oven has shut off…F0 E0No failure (default state).F1 E0EEPROM communication error (Tulsa/Celaya); Internal error (Oxford).F1 E1EEPROM checksum error (Tulsa/Celaya); Internal error (Oxford).F1 E2UL A/D error (Tulsa/Celaya); Internal error (Oxford).F1 E3Internal error (Oxford).F1 E4Model ID error (Tulsa/Celaya); Internal error (Oxford).F1 E5Internal error (Oxford)F1 E6Latch signal mismatch error (Tulsa/Celaya); Internal error (Oxford)F1 E7Internal error (Oxford)F1 E8Internal error (Oxford)F1 E9Internal error (Oxford)F1-E0EEPROM communications error.F1-E1EEPROM checksum failure.F1-E2UL A/D error(s).F2 E0Shorted keypad / stuck key.F2 E1Keypad disconnect / keypad disconnected.F2-E0Shorted key detected on keypad/membrane.F2-E1Keytail unplugged from control.F3 E0Top oven sensor open (main sensor open).F3 E1Top oven sensor shorted (main sensor shorted).F3 E2Meat probe shorted (Tulsa/CelayaF3 E3BAKE range over temperature (Tulsa/Celaya); Bottom oven sensor shorted is F3 E3…F3 E4Bottom oven sensor open (Oxford); CLEAN range over temperature (Tulsa/Celaya).F3 E5Lower oven sensor shorted (bottom sensor short).F3 E6Warming drawer sensor open (WD sensor open).F3 E7Warming drawer sensor shorted (WD sensor shorted).F3-E0Oven temperature sensor opened (open circuit).F3-E1Oven temperature sensor shorted.F3-E2BAKE/BROIL range over temperature condition.
View all 48 error codes
F3-E3CLEAN range over temperature condition.F4 E2Over temperature during cook cycle (temperature runaway error).F4 E3Over temperature during clean cycle (temperature runaway error).F4 E7Over temperature cavity 2 (temperature runaway error in second cavity).F5Door lock error during Clean (3-digit display / knob control).F5 E0Door and latch switches do not agree (door latch mismatch).F5 E1Latch or latch switch failure / no operating latch / latch not operating.F5 E2Door switch fault.F5 E4Latch switch fault.F5 E6Centertap voltage failure (Tulsa/Celaya).F5 E7Unlock door error / cannot unlock door.F5-E0Door and switches do not agree (door switch and door latch switch states are…F5-E1Door latch not operating.F5-E2Latch error during CLEAN cycle.F6 E4Lost communication between power board and display board.F6 E5Cancel key error.LocControl Lock is engaged; control panel pads are disabled to prevent unintended…PFPower failure has occurred; display shows 'PF' or a flashing time when power is…

Service modes (24)

  • 12-Hour Shut-Off Toggle (Style 1)["Press and hold DELAY for 5 seconds.","'12 HR SHUT-OFF ON' will appear on the display.","Press and…
  • All Tones Toggle (Style 1)["Press and hold CLOCK for 5 seconds.","'ALL SOUNDS OFF' will appear on the display.","Repeat to…
  • All Tones Toggle (Style 2)["Press and hold STOP TIME for 5 seconds.","'Snd OFF' will appear on the display.","Press and hold…
  • Control Lock["Make sure the oven and Timer are off.","Press and hold the 'Lock' key for 5 seconds.","A single…
  • End of Cycle Tones Toggle (Style 1)["Press and hold CONVECT for 5 seconds to turn END OF CYCLE TONES off.","Press and hold CONVECT for…
  • Fahrenheit/Celsius Toggle (Style 1)["Press and hold AUTO CLEAN for 5 seconds.","'TEMPERATURE UNIT CELSIUS' will appear in the…
  • Fahrenheit/Celsius Toggle (Styles 2 & 3)["Press and hold BROIL for 5 seconds.","Repeat to change back to Fahrenheit."]
  • Key Press Tones Toggle (Style 1)["Press and hold WARM (Cooking Options) for 5 seconds.","'KEY PRESS TONES OFF' will appear on the…
  • KitchenAid EZ373 & 520 Test ModeAvailable for first 60 seconds after power up. Press
  • KitchenAid GOC Clock Manual DiagnosticsWithin 120 seconds of power up
  • Last Error Code Recall["Press and hold CANCEL/OFF key for 5 seconds.","Last error code is displayed."]
  • Oven Temperature Calibration Adjustment (Style 1)["Press and hold OVEN LIGHT for 5 seconds until the oven display shows the current calibration…
  • Oven Temperature Calibration Adjustment (Styles 2 & 3)["Press and hold BAKE for 5 seconds until the oven display shows the current calibration (e.g…
  • Oxford GOC Clock Manual DiagnosticsWithin 120 seconds of power up
  • Reminder Tones Toggle (Style 1)["Press and hold BAKE for 5 seconds.","'REMINDER TONES OFF' will appear on the display.","Repeat to…
  • Reminder Tones Toggle (Style 2)["Press and hold TIMER SET for 5 seconds.","'rEP OFF' or 'OFF' will appear in the display.","Repeat…
  • Temperature Adjustment (Calibration)["Press and hold BAKE pad for five (5) seconds.","Current offset, if any, is shown in 3-digit…
  • Tone Pitch Toggle (Style 1)["Press and hold BROIL for 5 seconds.","'TONE PITCH LOW' will appear on the display.","Repeat to…
  • Tone Pitch Toggle (Style 2)["Press and hold DELAY START for 5 seconds.","'Snd LO' will appear on the display.","Repeat to…
  • Whirlpool EZ175 & 176 Self-Diagnostic Test ModeAvailable for first 60 seconds after power up. 1) Simultaneously press BAKE and CLOCK. 2) Display…
  • Whirlpool EZ300 Self-Diagnostic Test ModeAvailable for first 60 seconds after power up. 1) Sequentially press
  • Whirlpool EZ354, 357, 358, & 410 Test ModeAvailable for first 60 seconds after power up. Press
  • Whirlpool EZ625 Diagnostic Test1) Disconnect power for at least 15 seconds, then reconnect. 2) Within one minute of power up, press
  • Whirlpool GOC Clock Manual DiagnosticsWithin 120 seconds of power up

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass