Model reference

Whirlpool W10468733

Name: Whirlpool W10468733
Brand: Whirlpool

Washer

1 document20 error codes2 service modes

Available documentation

Tech Sheet

Diagnostic Guide36 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool W10468733.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

A09 on my Whirlpool W10468733

M+

No water detected entering washer or

From Tech Sheet W13441909, p.41:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure control board supply voltage at test points. Expected: 12 VDC and 5 VDC.

3.Inspect all connectors on the main control for corrosion or backed-out pins.

Part WPW10804018

Electronic control board

Error codes (20)

CodeMeaning

A09No water detected entering washer or pressure switch trip not detected; water…A10Long drain; if the drain time exceeds 4 minutes, the water valves turn off.F01No water detected entering washer or pressure switch trip not detected; water…F02Overflow condition; overflow level has been reached and lasts for more than 2…F03Long drain (factory test only); if the drain time exceeds 4 minutes, the water…F05Water temperature sensor error; NTC value is out of range (below 23°F/–5°C or…F06Drive motor tachometer error; control is unable to properly detect motor speed…F07Motor overspeed; if the motor speed is not controlled, the motor turns OFF and…F13Door lock error; failed attempts to lock the door within 10 seconds (only shown…F14EEPROM error; a communication error between the Central Control Unit (CCU) and…F21Serial communication error; the communication between the Central Control Unit…F22Load detected in washer during Clean Washer cycle.F23Pressure switch error; the wash level and level heater safety are switched on…F24Valve leakage/overflow failure; overflow level has been reached more than 5…F26Pump drive system error; the connection between pump and the CCU is lost during…F27Motor control unit error; motor reversing error.F28Motor control unit error; motor high speed switch error.F29Door switch error; door is not detected to be open and closed for 3 continuous…F30Door lock broken or door switch error; the door switch is detected open while…F88Suds lock; overdose of detergent detected during the wash cycle

Service modes (2)

Quick Test Mode["Close the door.","Rotate the cycle control knob and select the CLEAN WASHER cycle.","Ensure…
Universal Test Mode["Close the door.","Rotate the cycle control knob and select the CLEAN WASHER cycle.","Press…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass