mypros+
Model reference

Whirlpool WFC7500VW2

Washer

4 documents20 error codes4 service modes

Available documentation

Tech Sheet

  • Whirlpool Washer WFC7500VW0 WFC7500VW1 Tech Sheet18 pg
    Covers this model

Service Manual

  • 2008 24" Front-Loading Automatic Washer90 pg
    Covers this model
  • 2008 24" Front-Loading Automatic Washer - Job Aid90 pg
    Covers this model

Quick Reference

  • Quick Reference Manual8 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WFC7500VW2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (20)

CodeMeaning
A09No water detected entering machine or pressure switch trip not detected; water…A10Long drain; if the drain time exceeds 4 minutes the water valves turn off.F01No water detected entering machine or pressure switch trip not detected; water…F02Overflow condition; overflow level has been reached and lasted for more than 2…F03Long drain (factory test only); if the drain time exceeds 4 minutes the water…F05Water temperature sensor error; the NTC thermistor value is out of range (below…F06Drive motor tachometer error; the control is unable to properly detect motor…F07Motor overspeed; if the motor speed is not controlled then the motor switches…F13Door lock error; failed attempts to lock the door within 10 seconds (factory…F14EEPROM error; a communication error between the Central Control Unit (CCU) and…F21Serial communication error; the communication between the Central Control Unit…F22Loads detected during Clean Washer cycle; a load is detected in the drum during…F23Pressure switch error; the wash level and level heater safety are switched on…F24Valves leakage/overflow failure; overflow level has been reached for more than…F26Pump drive system error; connection between pump and the Central Control Unit…F27Motor control unit error; motor reversing error.F28Motor control unit error; motor high speed switch error.F29Door switch error; door is not detected to be open and close for 3 continuous…F30Door lock broken or door switch error; door switch is open while the door is…SudSuds lock; overdose of detergent detected during wash cycle

Service modes (4)

  • Quick Diagnostics Test["Close the door.","Switch the knob and select the CLEAN WASHER cycle.","Press START button 4 times…
  • Quick Test Mode["Close the door.","Ensure machine is in PROGRAM (SELECTION) mode. If not: PAUSE mode
  • Universal Diagnostics Test["Close the door.","Rotate the knob and select the CLEAN WASHER cycle.","Press CANCEL/DRAIN button…
  • Universal Test Mode["Close the door.","Rotate the knob and select the CLEAN WASHER cycle.","Press CANCEL/DRAIN button…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass