Model reference

Whirlpool WFXD5200UC

Washer

1 document36 error codes2 service modes

Available documentation

Service Manual

Wfmc/wfxd Washer Training Manual73 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WFXD5200UC.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

d:01 on my Whirlpool WFXD5200UC

M+

Motor control short circuited – faulty

From Tech Sheet W13672328, p.20:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drive motor winding resistance. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand. Inspect the belt and pulley for glaze or wear.

Part W10006384

Drive motor

Error codes (36)

CodeMeaning

d:01Motor control short circuited d:02Motor control interruption d:03Damaged motor control temperature sensor d:06Motor control NTC relay failure d:07Motor control (inverter) failed or motor shorted d:08Motor speed sensor failed d:09Voltage too high d:10Power limiter switch off d:11Voltage too low d:12Motor control high current switch off d:13Motor control high temperature switch off d:14Motor control high temperature warning d:15Power limiter warning d:16Motor high temperature switch off d:17Motor high temperature warning d:18Peak voltage too high E:01Door open E:02Door lock doesn't unlock E:03Door lock doesn't lock E:04Door control broken E:05NTC open-circuited E:06NTC shorted E:07Unexpected heating (heater on at wrong time)E:08Heater doesn't shut off E:09Communication lost to motor E:12Water supply time exceeded E:13Drain pump time exceeded E:14Overflow level exceeded E:20Spinning aborted due to unbalanced load E:21Excessive foam

View all 36 error codes

E:22Frequency synchronization failed E:24Motor power relay failed Er:10Flow meter gives wrong values Er:11No water flow within 6 minutes Er:15Pressure sensor gives failure voltage level Er:16Cannot calibrate pressure sensor

Service modes (2)

WFMC32/WFXD52 Test Program (Diagnostic Mode)["Rotate cycle selector knob to Off position to reset.","Push and hold Spin Selection and Delay…
WFMC64/WFXD84 Test Program (Diagnostic Mode)["Rotate cycle selector knob to Off position to reset.","Push and hold Menu and Select buttons at…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass