mypros+
Model reference

Whirlpool WTW6700TW0

Washer

13 documents23 error codes3 service modes

Available documentation

Tech Sheet

  • Whirlpool Washer WTW6700TW1 Tech Sheet16 pg
    Covers this model
  • Tech Sheet - W10026628 - Rev A_W1002662816 pg
    Covers this model
  • Tech Sheet - W10026634 - Rev B16 pg
    Covers this model

Service Flash

  • Service Pointer 8178742 - Cabrio and Bravos Washers Intermittent Water Leak4 pg
    Covers this model
  • F1 Error Code Service Pointer Cabrio Washer2 pg
    Covers this model
  • F1 Error Code Service Pointer - HE Top Load Washers2 pg
    Covers this model
  • Service Pointer - 8178767 (F1 Error Code)2 pg
    Covers this model
  • Service Pointer 8178742 Intermittent Water Leak4 pg
    Covers this model
  • Technical Service Pointer - W10545059 - Rev A (Added Drain Port)6 pg
    Covers this model

Training

  • Training Pointer - Replacement Bearing Procedure for Top Load, Direct Drive Washers16 pg
    Covers this model

Job Aid

  • Instruction Sheet for Bearing Replacement Procedure12 pg
    Covers this model

Installation Guide

  • Instruction Sheet2 pg
    Covers this model

Other

  • 81787671 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WTW6700TW0.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (23)

CodeMeaning
dLLid Lock FailuredULid Unlock FailureF1Pressure Signal Out-of-RangeF2Keypad/User Interface FailureF40ATC Thermistor Open/ShortF41Motor RPS Thermistor Open/ShortF42Heater in unknown stateF43Heater is continuously ONF44Heater cannot be turned ONF50Motor StalledF51Motor RPS FailureF52Motor Stop FailureF53Motor Control OvertempF54Motor Control OvercurrentF72Basket Re-engagement FailureHCHot, Cold ReversedLdLong DrainLFLong FilllidOpen/Close LidoLOverloadedPoPump OutSdSuds DetectionuLUnbalanced Load

Service modes (3)

  • Automatic Diagnostic Test Mode1. Washer must be in standby mode (plugged in with all indicators off, or with only Clothes Clean…
  • Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release within 4 seconds
  • Manual Diagnostic Test Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass