Maytag Dryer Error Code FC E6

FC E6 on a Maytag dryer indicates a Model Setup Export Failure. This means the dryer attempted to transfer its machine configuration data to a USB stick and the process failed. It is typically encountered during service or programming procedures, not during regular drying cycles. Checking the USB stick and reviewing the model and serial number settings in the Help Mode Sub Menu are the first steps toward resolving it.

No, FC E6 is not a safety-related error. It refers only to a failure in transferring setup data to a USB device, which is a service and programming function. This code does not indicate any issue with the dryer's heating system, motor, or electrical components that would pose a risk during normal use.

In most cases, FC E6 can be resolved without any parts cost, since it typically involves correcting USB compatibility or reprogramming the model and serial number settings. If a technician is needed to access and correct the Help Mode Sub Menu programming, a service call fee in the range of $75 to $150 is common depending on your area. In the unlikely event that the main control board has failed and requires replacement, parts and labor costs could range from $200 to $450 or more.

Start by removing the USB stick and inspecting it for damage, then reinsert it firmly and retry the export. If the error persists, try a different USB drive to rule out a compatibility or formatting issue. You should also access the Help Mode Sub Menu to verify that the model and serial number are correctly programmed in the dryer's control settings. If the data fields are incorrect or missing, correcting them and retrying the export should clear the error.

A simple power reset is unlikely to permanently clear FC E6 if the underlying cause is an incompatible USB stick or incorrect model and serial programming. The error will likely return when the export is attempted again under the same conditions. Addressing the root cause, either by correcting the USB device or fixing the programming data, is necessary to resolve the error properly.