Whirlpool Cooktop Error Code F0E6

F0E6 indicates a product supply error detected by the IPC (Induction Power Control) module. The error can be caused by a mains line frequency outside 60 Hz plus or minus 2 Hz, internal Vbus undervoltage or overvoltage, a dropped 15V supply rail, ADC self-diagnostic failure, or an internal fuse track action. The IPC is the primary component involved in this fault.

No. F0E6 signals an internal power supply fault in the IPC, which means the cooktop's power regulation may be compromised. Continuing to operate the appliance under these conditions could create a risk of further component damage or an electrical hazard. Discontinue use until the fault is diagnosed and resolved.

If the issue is a mains frequency problem from the utility supply, there may be no part cost at all, only a service call fee for diagnosis, typically in the range of $75 to $150. If the IPC module requires replacement, part costs can range from $150 to $400 or more depending on the model, plus labor, bringing total repair costs to roughly $250 to $600.

The first step, checking the mains line frequency at the phase connected to the IPC, can be done by a knowledgeable DIYer with the right meter. If frequency is within 60 Hz plus or minus 2 Hz and the error remains, the IPC module must be replaced, which involves working inside a high-voltage appliance. That repair is best handled by a qualified technician.

A power reset may temporarily clear the display, but if the underlying cause, whether a utility frequency issue or an internal IPC failure, has not been corrected, the error will return. An internal fuse track action within the IPC is a permanent hardware failure and cannot be cleared by any reset.