mypros+
Model reference

Electrolux 5995413084

Washer

3 documents37 error codes5 service modes

Available documentation

Service Manual

  • 3.0 Cu. Ft. HORIZONTAL AXIS WASHER SERVICE MANUAL96 pg
    Covers this model
  • SERVICE MANUAL 3.0 Cu. Ft. HORIZONTAL AXIS WASHER GOOD & BETTER MODELS96 pg
    Covers this model
  • SERVICE MANUAL 3.0 Cu. Ft. HORIZONTAL AXIS WASHER GOOD & BETTER MODELS93 pg
    Covers this model
MyPros+ Max

Diagnose your Electrolux 5995413084.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (37)

CodeMeaning
E11Fill time too longE13Water leak in tub or air leak in air bell.E14Reed switch faultE21Water not pumping out fast enough.E23Drain pump relay on control board failed.E24Drain pump relay on control board failed.E31Better models onlyE35Better models onlyE41Control board thinks the door switch is open.E42Door remains locked after cycle is completed.E43Control board problem.E44Control board problem.E45Control board problem.E46Control board problem.E47Board thinks the door PTC circuit is open in spin.E48Board thinks the door PTC circuit is closed.E52Bad signal from tachogenerator.E55Motor overheating.E56High motor current.E57High current on inverter.E58High current on motor phase.E59No tachogenerator signal for 3 seconds.E5AHigh temperature on heat sink.E5BHigh temperature on heat sink.E5CHigh temperature on heat sink.E5DCommunication problem between control board and speed control board.E5ECommunication problem between control board and speed control board.E5FCommunication problem between control board and speed control board.E67Input voltage on microprocessor incorrect.E75Better models only
View all 37 error codes
E76Better models onlyE95Communication error.EB1Incoming power frequency out of limits.EB2Incoming line voltage above 130 VAC.EB3Incoming line voltage below 90 VAC.EF1Clogged drain pump.EF2Too much soap / oversudsing.

Service modes (5)

  • Clear Stored Error Code["Place the control into Diagnostic Test Mode.","Turn the program knob clockwise 9 clicks from the…
  • Diagnostic Test["On non-digital display models, turn the Program Knob to start position (Drain/Spin). On digital…
  • Error Code Recall["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the START and Pause…
  • Recall Error Code["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the Start and…
  • Recall Error Code (Good Models)["Wake the machine by pressing any button.","Wait 5 seconds.","Press and hold the START and Pause…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Electrolux washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax