mypros+
Model reference

Maytag W10261300

Washer

1 document22 error codes9 service modes

Available documentation

Tech Sheet

  • Funcionamiento BÁsico De La Lavadora Comercial De Carga Frontal16 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag W10261300.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
d13Coin 2 sensor errord16Generation 2 debit card reader errord5Coin 1 sensor errord9Low voltage detection errorF01UCC (Central Control Unit) errorF11UCM (Motor Control Unit) failure, possibly caused by repeated low voltage or…F20Water supply error (no water detected entering the washer or insufficient water…F21Drain error (washer unable to drain water or insufficient drain flow).F22Door lock errorF24Water temperature sensor out of range (23°F to 217°F / -5°C to 103°C).F25Tachometer errorF26Door switch errorF27Overflow problemF28Communication failure between the UCC and UCM.F29Motor overheating detected by the UCM.F30Drive motor speed/operation error.F31Motor speed/MCU communication error.F33Pump disconnectedF34A load has been detected in the washer during the Washer Cleanout cycle.F70Communication failure between the UCC and the User Interface (UI).F73User Interface (UI) failureF74User Interface (UI) failure

Service modes (9)

  • Diagnostic Mode (Flash Mode)["First enter Programming/Setup mode.","Press and hold the DELICATES & KNITS button for 1 second…
  • Fault Code Display Mode["PD Models
  • Flash Mode - Credit Cycle["Enter Flash Mode (entire display flashing).","Press the PERMANENT PRESS button to grant a cycle…
  • Flash Mode - Manual Overall Test["Enter Flash Mode (entire display flashing).","Press the WHITES button to start the Manual Overall…
  • Flash Mode - Quick Drain and Spin["Enter Flash Mode (entire display flashing).","Press the COLORS button to start the Quick Drain…
  • Flash Mode - Quick Overall Test["Enter Flash Mode (entire display flashing).","Press the WOOLENS button to start the Quick Overall…
  • Flash Mode - Washer Cleanout Cycle["Enter Flash Mode (entire display flashing).","Press the BRIGHT button to start the Washer…
  • Help Mode["PD Models
  • Programming Mode (Setup Mode)["PD Models

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass