Model reference

Samsung WF316LAS/XAA-0000

Washer

4 documents22 error codes10 service modes

Available documentation

Service Manual

Washing Machine Service Manual89 pg
Covers this model
Washing Machine Service Manual89 pg
Covers this model
WASHING MACHINE SERVICE Manual89 pg
Covers this model
Washing Machine Service Manual89 pg
Covers this model

MyPros+ Max

Diagnose your Samsung WF316LAS/XAA-0000.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Samsung Washer

2E on my Samsung WF316LAS/XAA-0000

M+

Voltage for motor control bus is over

From Service Manual 277793, p.45:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure drive motor winding resistance. Expected: 2 to 6 ohms between winding pairs.

3.Rotate the drum by hand. Inspect the belt and pulley for glaze or wear.

Part DC31-00055D

Drive motor

Error codes (22)

CodeMeaning

2EVoltage for motor control bus is over specified limit (diagnostic code 91) or…3EOver-current is detected 7ESilver Care Kit (Silver Care PCB) Failure.8EMEMS Sensor Failure (No MEMS Sensor Check Signal).bEMotor hall sensor signals come out without motor operation.dcUnbalance or cabinet bump is detected during final spin, which prevents the…dLDoor is detected as open when the motor is operating.dSDoor is detected as open while it is trying to lock the door.E2Jammed Key E3MICOM is attempting to drive the motor but is not getting any response signals…EEEEEEPROM Fault FLDoor fails to lock after 3 attempts.HrHeater Relay Failure (No Heater Relay Check Signal).LEWater Level Sensor Trouble LODoor fails to unlock after 3 attempts.ndThe water level fails to drop below the Reset Water Level within 15 minutes.nFWhen the filling continues for more than 16 minutes or there is no change of…OEA fault is detected in the water level sensor PFPower failure occurred during washing SrSystem Relay (Main Relay) Failure SUdSSuds is detected during the washing session tEAbnormal high/low temperature or resistance (Thermal sensor or PBA) resistance.

Service modes (10)

Board Input Test Mode1
Continuous Run Mode1
Cycle Count Check Mode1
Diagnostic Code Check Mode1
EEPROM Reset Mode1
Fast Time Down Test Mode1
Quick Spin Test Mode1
Quick Test Mode1
S/W Version Check Mode1
Special Test Mode1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass