Model reference
Samsung WF316LAW
Washer
11 documents22 error codes10 service modes
Available documentation
Service Manual
- LG Samsung WF306BHWXAA Service Manual Product Specification4 pg
- Samsung Front Load Washer88 pg
- Washing Machine Service Manual104 pg
- Washing Machine Service Manual104 pg
- Washing Machine Service Manual89 pg
- Washing Machine Service Manual89 pg
- WASHING MACHINE SERVICE Manual89 pg
- Washing Machine Service Manual89 pg
Bulletin
- SERVICE BULLETIN - Water Leak due to Missing CAP-DRAWER1 pg
Service Flash
- Service Tip - Extended Spin Cycles (extended total wash time)1 pg
Tech Tip
- Noise/Vibration Service Tip1 pg
MyPros+ Max
Diagnose your Samsung WF316LAW.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (22)
CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EOver-current is detected7ESilver Care Kit (Silver Care PCB) Failure.8EMEMS Sensor FailurebEMotor hall sensor signals come out without motor operation.dcUnbalance or cabinet bump detected during final spin, preventing drum from…dLDoor is detected as open when the motor is operating.dSDoor is detected as open while it is trying to lock the door.E2Jammed KeyE3MICOM is attempting to drive the motor but is not getting any response signals…EEEEModel option Error displayed during Quick Test Mode (Need to replace PCB Assy).FLDoor fails to lock after 3 attempts.HrHeater Relay Failure (No Heater Relay Check Signal).LEWater Level Sensor TroubleLODoor fails to unlock after 3 attempts.ndThe water level fails to drop below the Reset Water Level within 15 minutes.nFFilling continues for more than 16 minutes or there is no change of water level…OEWater level sensor data (frequency) shows water level is at or above the…PFPower failure occurred during washingSrSystem Relay (Main Relay) FailureSUdSSuds detected during washing sessiontEAbnormal high/low temperature or resistance (Thermal sensor or PBA) resistance.Service modes (10)
- Board Input Test ModeDuring Special Test Mode, press the Extra Wash Key.
- Continuous Run Mode1
- Cycle Count Check ModeDuring Special Test Mode, press the Signal Key.
- Diagnostic Code Check ModeDuring Special Test Mode, press the Silver Wash (Rinse Water +) Key
- EEPROM Reset Mode1
- Fast Time Down Test ModeDuring Special Test Mode, press the Temp Key.
- Quick Spin Test ModeDuring Special Test Mode, press Delay Start and Silver Wash Keys (Rinse Water + Key) for 3 seconds.
- Quick Test Mode1
- S/W Version Check ModeDuring Special Test Mode, press the Soil Level Key.
- Special Test Mode1
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass