mypros+
Model reference

Samsung WF45R6300AC

Washer

1 document28 error codes6 service modes

Available documentation

Service Manual

  • Washing Machine Drum Type Customer Repair Guide35 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung WF45R6300AC.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (28)

CodeMeaning
1CWater level sensor fault due to damaged/clogged/folded hose, faulty sensor…3CMotor driving error and hall sensor error caused by restrained revolutions…4CWater supply error due to foreign material in water supply valve, disconnected…4C2Water supply error where cold and warm water supply hoses are wrongly…5CDrain error due to damaged pump motor impeller, wrong voltage supplied…8CMems PBA error or data error detected.8C1Mems PBA error detected.8C2Vibration noise during SPIN cycle with small amount of clothes causing…9C1Power error due to incorrect operating voltage (under or over voltage), use of…9C2Power error due to incorrect operating voltage (under or over voltage), use of…ACCommunication error between the sub and main PBAs; signals not sensed due to…AC3Communication error between the DR Module and main PBAs due to incorrect/loose…AC4Communication error between the WIFI Module and main PBAs due to…AC5Communication error between the LCD Module and main PBAs due to incorrect/loose…AC6Communication error between the Inverter PBA and main PBA due to…BC2Switch error (main relay error) caused by jammed/stuck button due to control…DCDoor error due to deformed door hook causing switch contact error, door pulled…DC1Door error occurring during Boil wash because the door is pushed due to…DC3Add door error with main PCB fault or bending connector.DDCAdd door is opened; add door switch, barrier, or lock module movement not…HCHeater error due to short-circuited or disconnected washing heater wire, heater…HC1Heater error due to short-circuited or disconnected washing heater wire, heater…LCWater leakage error due to heater engagement fault, air hose out of place…OCOverflow error due to continuous water supply from non-working water level…SFMicro Controller Operation Fail (system error).SUDToo much foaming detected; displayed while foaming is being removed, normal…TC1Temperature sensor error due to faulty washing/dry temperature sensor…UBUnbalance error caused by laundry contents creating an unbalanced load…

Service modes (6)

  • Automatic check modeEnter Smart Install mode
  • Diagnostic Code Check (Diagnosis Information Display Mode)Enter Smart Install mode
  • Manual check modeEnter Smart Install mode
  • S/W version CheckEnter Smart Install mode
  • Smart InstallFrom standby mode, set the scheduled time to 17:00, then press Start/Pause for 7 seconds.
  • Smart Install Result EnquiryWhile 'AS' is displayed, press 'Delay End + Start/Pause' button.

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass