mypros+
Model reference

GE PGS975SEMSS

Range

38 documents66 error codes41 service modes

Available documentation

Service Manual

  • Gas Slide-In Ranges Owner's Manual136 pg
    Covers this model
  • GE Profile Wall Oven Technical Service Guide62 pg
    Covers this model
  • GE Consumer Service Training Technician Manual GE & Profile 30" Built-in Wall Ovens33 pg
    Covers this model
  • Profile 30-in. Free Standing Double Oven Range Technical Service Guide75 pg
    Covers this model
  • Profile 30-in. Free Standing Double Oven Range75 pg
    Covers this model
  • Profile 30-in. Free-Standing Double Oven Range Technical Service Guide29 pg
    Covers this model
  • GE Consumer & Industrial Technical Service Guide - Profile 30-in. Free-Standing Double Oven Range29 pg
    Covers this model
  • Profile 30 in Free Standing Induction Range PHB925SB1SS Technical Service Guide66 pg
    Covers this model
  • Technical Service Guide 2000 Profile Series - Drop-in Electric Ranges32 pg
    Covers this model
  • GE Profile Series Drop-In Range Service Manual32 pg
    Covers this model
  • Profile 30-in. Slide-in Induction and Radiant Ranges Technical Service Guide86 pg
    Covers this model
  • GE Profile Induction Range122 pg
    Covers this model
  • TECHNICAL SERVICE GUIDE Profile Dual Fuel and Profile All Gas Slide-In Ranges63 pg
    Covers this model
  • GE Profile Induction Free Standing Electric Slide In Range Service Manual117 pg
    Covers this model
  • GE Appliances Profile 30-in. Slide-in Induction and Radiant Ranges Technical Service Guide86 pg
    Covers this model
  • Profile 30-in. Slide-in Induction and Radiant Ranges Service Guide86 pg
    Covers this model
  • Dual Cavity Gas, Free Standing Ranges Café, Profile & GE67 pg
    Covers this model
  • GE Profile Wall Oven PT925 Technical Service Guide62 pg
    Covers this model
  • GE Profile Wall Oven P1925 Technical Service Guide62 pg
    Covers this model
  • GE Gas Slide-In Ranges Technical Service Guide80 pg
    Covers this model
  • GE Double Oven Range PB970 PB975 Profile 30 inch Free Standing Service Manual75 pg
    Covers this model
  • Profile Dual Fuel and Profile All Gas Slide-In Ranges Technical Service Guide63 pg
    Covers this model

Service Flash

  • Service Letter / Lettre Technique - LP Conversion2 pg
    Covers this model

Bulletin

  • GE Oven RA03 08 Hot or melted knobs due to poor door gasket seal1 pg
    Covers this model

Training

  • GE Profile 30" Double Wall Oven PT960 Training Presentation109 pg
    Covers this model
  • GE & Profile 30" Built-in Wall Ovens Technician Manual33 pg
    Covers this model
  • GE Consumer Service Training Technician Manual - GE & Profile 30" Built-in Wall Ovens33 pg
    Covers this model
  • Profile Double Oven Range II105 pg
    Covers this model
  • Technical Service Guide 2000 Profile Series - Drop-in Electric Ranges33 pg
    Covers this model
  • GE Profile Performance™ 30" Stainless Steel Convection Range Technical Service Guide33 pg
    Covers this model
  • Training Bulletin - Profile Range JB850DP/SP & JB855DP/SP Lower Oven Bake Element1 pg
    Covers this model
  • GE Profile 30" Free-Standing Dual Fuel Range - Training Bulletin3 pg
    Covers this model
  • GE Profile Wall Oven73 pg
    Covers this model
  • GE Profile 30" Self-Clean Gas Ranges with Convection Oven - Training Bulletin TB01 034 pg
    Covers this model
  • GE Profile 30" Self-Clean Gas Ranges with Convection Oven4 pg
    Covers this model

Installation Guide

  • JTP56BABB - GE Profile™ 30" Double Wall Oven2 pg
    Covers this model
  • JGSP44WEYWW—GE Profile™ 30" Slide-In Gas Range Dimensions and Installation Information2 pg
    Covers this model

Other

  • GE Profile Drop-In Ranges32 pg
    Covers this model
MyPros+ Max

Diagnose your GE PGS975SEMSS.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (66)

CodeMeaning
331Open oven sensor fault code stored in EEPROM memory; causes both cooktop and…bAd LinETerminal block cord miswire detected, or 120VAC not present between MJ21-5 and…bAd LinE bAdVoltage monitor error indicating a terminal block cord miswire; appears if…CONTROL LOCKEDThe control panel has been locked to prevent accidental operation or use by…ERRCooktop lockout errorFFunction error code indicated by 'F' followed by a number or letter flashing in…F0Shorted OFF key detected on the control panel.F1Failed transistor in the electronic control board.F100LED error on Burner Touch Board (when equipped).F2Over temperature conditionF20xTemperature inside oven cavity exceeds 600°F with door unlocked.F21xTemperature inside oven cavity exceeds 900°F with door unlocked.F3Open sensor circuit, failed sensor, sensor lead shorted to oven frame (grounded…F30xShorted oven sensor (under 950 ohms).F31xOpen oven sensor (over 2950 ohms).F32xTemperature measurement circuit redundancy check within Main Logic Board bad.F33xMeat probe or jack shorted.F4Sensor lead shorted to the oven frame (grounded out).F40xLIN comm error to/from RPSM Aux Board (when equipped).F5Intermittent sensor harness connections.F600LIN comm error within Main Logic Board.F610LIN comm error to slaves, such as RPSM.F611LIN comm error to slaves, such as RPSM.F612Line power error detected by RPSM.F620LIN comm error to/from RPSM Aux Board (when equipped).F621LIN comm error to/from RPSM AUX Board (when equipped).F622Line power error detected by RPSM.F640No LIN comm between Main Logic Board and Induction Bridge Board (when equipped).F7Shorted matrix or START key.F70xCLEAR/OFF touch pad error.
View all 66 error codes
F710Any other touch pad error.F720Main Logic Board internal touch key chip signal error.F73060 Hz square wave not getting to touch key chip on Main Logic Board.F74060 Hz square wave not getting to touch key chip on Main Logic Board.F75060 Hz square wave not getting to touch key chip on Main Logic Board.F76060 Hz square wave not getting to touch key chip on Main Logic Board.F77060 Hz square wave not getting to touch key chip on Main Logic Board.F78060 Hz square wave not getting to touch key chip on Main Logic Board.F790Main Logic Board internal touch key chip signal error.F7A0Main Logic Board internal touch key chip signal error.F7B0Main Logic Board internal touch key chip signal error.F8EEPROM data shift failure.F800Main Logic Board memory error.F810Main Logic Board memory error.F820Main Logic Board EEPROM memory error.F9Cooling fan stalls while above 650°F; open thermal switch in yellow leads.F90xDoor Lock Unlock-Home signal became untrue during cooking.F91xDoor Lock Unlock-Home signal became untrue during clean.F92xBoth the Lock-Home and Unlock-Home switches are closed simultaneously.FA00Device not found within Induction Cooktop module.FA10Induction cooktopFA30Induction cooktopFA40Induction cooktopFA47Enable signal not getting from Main Logic Board J241 pin 8 to Cooktop Bridge…FA5xInduction cooktop burner sensor too hot (F-code not logged).FA6xInduction cooktopFA7xInduction cooktop generator board temperature sensor open or DC problem.FA8xInduction cooktopFA9xInduction cooktopFAAxInduction cooktopFCDoor lock error.FdShorted meat probe (Profile/Convection models only).FFLoss of latch motor safety circuit.LOCGas lockout valve positioning switch failure causing the lockout motor to run…OVEN TOO HOT FOR SENSOR COOKING--USING ALTERNATE METHODA sensor cooking button was pressed when the internal oven temperature was…SENSOR ERRORThe humidity sensor failed to detect steam during a sensor cooking feature…

Service modes (41)

  • 12-Hour Shutdown Disable["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Auto Recipe Conversion Toggle["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Bake Temperature Calibration1. Press Bake pad. 2. Select any temperature above 500°F by pressing the + pad. 3. Immediately…
  • Child Lockout (Profile/Convection models)Press and hold +/- pads along with STOP TIME pad for approximately 2 seconds
  • Clock Display Mode (12hr/24hr/Blackout)["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Control LockTouch and hold the 9 and 0 pads for 3 seconds
  • Control Lockout["Touch the 9 and 0 pads at the same time for 3 seconds until the display shows LOC ON."]
  • Cook and Hold Toggle["Touch the BAKE and BROIL HI/LO pads at the same time for 3 seconds until the display shows…
  • Demo Mode (1.9 Series)1
  • Demo Mode (2.1 Series)1
  • diagnosticAccess diagnostic mode through the ERC control to retrieve logged error codes from ERC memory…
  • End of Cycle Tone EliminationPress and hold the CLEAR/OFF pad for 10 seconds to eliminate the repeating tone every 6 seconds at…
  • End-of-Cycle Tone Cancel["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Error Code Access["Press the UPPER START pad and the CLOCK pad for 3 seconds to access ERC failure codes."]
  • F Code RecallPress TIMER, CLOCK, MIN DOWN (or 9) together to recall stored F codes.
  • F-code retrievalPress TIMER ON + CLOCK + UPPER START pads together
  • F-Code Retrieval ModePress TIMER ON, CLOCK, and START simultaneously
  • F0 Recovery / LOC REF Reset1
  • Fahrenheit or Celsius Temperature Selection1
  • Fahrenheit/Celsius Selection["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Failure Code AccessSimultaneously press the upper oven Start and Timer/Clock pads
  • Failure Code RecallPress TIMER, CLOCK, and MIN DOWN (or 9) together to recall stored F codes.
  • Failure Code Retrieval["Press TIMER ON, CLOCK, and START simultaneously.","Display shows F-cd and prompts for UPPER or…
  • Increase/Decrease Pad Speed Adjustment (Profile/Convection models)Press and hold +/- and Timer pads for 2 to 3 seconds
  • Key Panel TestTouch each pad individually
  • LIN TestPress the OVEN LIGHT pad
  • Oven Calibration Mode1
  • Oven Thermostat Adjustment["Press the BAKE pad.","Set the oven temperature to 550°F.","Immediately, before 'ON' appears…
  • Range Lock-Out["Turn all surface burners off.","Touch and hold the RANGE LOCK-OUT pad for 3 seconds until the…
  • Sales / Demo Mode["Install Demo Kit per instructions:","1
  • Sales/Demo ModeInstall demo kit (model PB978 Demo Kit)
  • Sensor Quick Test1
  • Service Mode["Press and hold the Upper BAKE pad and the BROIL pad until 'SF' appears in the display.","Then…
  • Service Mode (Product TEST)1
  • Special Features (SF) Mode["Touch the BROIL HI/LO and BAKE pads at the same time and hold for 3 seconds until the display…
  • Special Features ModeWith display showing time of day, touch the upper oven BROIL HI/LO and BAKE pads at the same time…
  • Special Features Mode (SF)Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows SF.
  • Test ModeWithin 3 minutes after power up, press 1 and 5 pads together
  • Thermostat AdjustmentTouch the upper oven BROIL HI/LO and BAKE pads at the same time until the display shows SF
  • Tone Volume Adjustment["Touch the BROIL HI/LO and BAKE pads at the same time for 3 seconds until the display shows…
  • Touch Panel TestPress each pad on the touch panel followed by the START pad.

Full entry steps, exit procedures, and test sequences are available in Max.

Related GE range models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass