Model reference
Maytag MAH6500AW*
Washer
10 documents32 error codes19 service modes
Available documentation
Tech Sheet
- Technical Information - Front Load Washer MAH6500*17 pg
- tech sheet 16025862F fr14 pg
Service Manual
- Technical Information Neptune Front Load Washer15 pg
Bulletin
- Technical Bulletin - TDL-0025-B New software changes operation of Spin Cycle2 pg
- Technical Bulletin - Neptune Door adjustment2 pg
- Technical Bulletin - Serial tag missing model and serial numbers1 pg
- Technical Bulletin - Motor Drive System Neutral Feed Issue1 pg
Service Flash
- Washer Stops In Mid Cycle and or Flashes A Code1 pg
Other
- TDL 0041 S1 pg
- TCL 0015B B1 pg
MyPros+ Max
Diagnose your Maytag MAH6500AW*.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (32)
CodeMeaning
01No drain02Door will not unlock after 11 attempts.03No fill04Door will not lock after 11 attempts.05Continuous unbalance circuit during spin only.06Locked rotor07Heater not heating08Water level sensor failure10Unbalanced load at low speed11Non-volatile memory error15Stuck key16High speed not reached due to high motor torque17Door actuator switch not detected as open since final spin18Door switch detected open during cycle19Door lock sensor or motor control relay failure20Door switch input detected open during cycle.21Sensor switch failure on machine control board22Door switch detected open during cycle23Door will not unlock24Motor overspeed25Motor tachometer signal present although the motor is not running28Valve thermistor failure29Tub collector thermistor failuredoDoor openFLLock failureLOLockedLrLocked rotorndNo drainnFNo fillodOpen doorService modes (19)
- Board Input TestIn service mode, press the 'hand wash' button.
- Board Output TestIn service mode, press the 'rinse' button.
- Diagnostic CodesWhile in Service Mode, press the Presoak key
- Diagnostic Codes AccessIn service mode, press the 'presoak' button
- Diagnostic Codes ViewingWhile in Service Mode, press the Presoak key
- Displays Software Revision NumberWhile in Service Mode, press the Light Soil key.
- Fast Time Down TestWhile in Service Mode, press the Quick key.
- Membrane Keypad TestIn service mode, press the 'wrinkle free' button.
- Membrane Pad CheckWhile in Service Mode, press the Wrinkle Free key
- Membrane Pad Check TestWhile in Service Mode, press the Wrinkle Free key.
- Motor Control Board Output Test1) Disconnect washer power. 2) Remove front panel and disconnect connector JP4 from motor control…
- Motor Torque DisplayIn service mode, press the 'normal' button.
- Quick Service CycleIn service mode, press the 'delicates' button.
- Quick Spin TestIn service mode, press the 'spin' button.
- Quick Stop Time TestIn service mode, press the 'quick' button.
- Service ModePress and hold the 'delicates' and 'heavy soil' buttons simultaneously for 3 seconds
- Shows Motor TorqueWhile in Service Mode, press the Medium key.
- Software Revision DisplayIn service mode, press the 'light soil' button.
- Software Revision Number DisplayWhile in Service Mode, press the Light Soil key.
Full entry steps, exit procedures, and test sequences are available in Max.
Related Maytag washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass