mypros+
Model reference

Maytag W11449148A

Washer

1 document25 error codes7 service modes

Available documentation

Service Manual

  • Tech Manual - W11449148 - Rev A24 pg
    Covers this model
MyPros+ Max

Diagnose your Maytag W11449148A.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (25)

CodeMeaning
d13Coin 2 error; the Coin 2 sensor is detected as blocked for 8 seconds.d16Generation 2 debit card reader error; no communication from installed debit…d5Coin 1 error; the Coin 1 sensor is detected as blocked for 8 seconds.d9Low voltage detection error; incoming voltage detected below 90 VAC for 8…F01CCU communication error, pump drive in CCU fails to activate, or one of the…F03Accelerometer component failure; the X, Y, and Z limits are outside of the…F04CCU dislodged from mounting or accelerometer failure on CCU.F11Motor Control Unit (MCU) has a failure, possibly due to a repeating under or…F20No water detected entering washer; first level of pressure switch not reached…F21Long drain; the drain time exceeds 8 minutes without reaching reset level in…F22Door lock error; washer makes several attempts to lock the door without success.F24Water temperature sensor value is out of range (23°F to 217°F / -5°C to 103°C).F25Tachometer error; the MCU is unable to properly detect motor speed, washer…F26Door switch error; the door switch circuit is open for 5 seconds while the door…F27Overflow condition; the overflow contact on the pressure switch is closed for…F28Communication failure between the Central Control Unit (CCU) and Motor Control…F29Door unlock error; the door is unable to unlock after 6 tries.F31Overheating of motor; the heat sink exceeds 212°F (100°C).F33Pump disconnected; the electrical connection between the pump and the CCU is…F34Load detected in washer during Washer Cleanout Cycle.F37Water level out of range low; water level has been detected to be below the…F38Water level out of range high; water level has been detected to be above the…F70Communication failure between CCU and User Interface (UI).F73UI failure; communication error within the User Interface, possibly from a…F74UI failure; communication error within the User Interface, possibly from a…

Service modes (7)

  • Help Mode (dAS Mode)["Open the service door or insert a manual diagnostic card.","The message dAS will appear in the…
  • Help Mode (PD Models)["Open the service door.","Press the LOWER MIDDLE keypad until the display reads 2.XX.","Press the…
  • Service Access Code (key dance)["Only available on washers set to free vend (6 00) with no Special Pricing set-up and Coin/Debit…
  • Service Diagnostic Test Modes["Make sure power is turned off, then remove the service door on metercase models, or remove the…
  • Service/Set-up Mode (PD Models)["Insert service access door key, turn, and lift to remove service access door.","The washer enters…
  • Service/Set-up Mode (PR Models with set-up card)["Insert a set-up card (supplied by the reader manufacturer) into the card slot."]
  • Service/Set-up Mode (via service connector removal)["Unplug washer or disconnect power.","Open console, disconnect plug on service connector, close…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Maytag washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass