mypros+
Model reference

Samsung WF316L

Washer

4 documents22 error codes10 service modes

Available documentation

Service Manual

  • ABS Laundry Samsung Front Load Washer Model WF316L88 pg
    Covers this model
  • Samsung Front Load Washer Model WF316L Service Manual88 pg
    Covers this model
  • SERVICE Manual WASHING MACHINE88 pg
    Covers this model
  • Samsung Front Load Washer88 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung WF316L.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (22)

CodeMeaning
2EVoltage for motor control bus is over or under specified limit (code 91 = over…3EOver-current is detected7ESilver Care Kit (Silver Care PCB) Failure.8EMEMS Sensor Failure (No MEMS Sensor Check Signal).bEMotor hall sensor signals come out without motor operation.dcUnbalance or cabinet bump is detected during final spin, which prevents the…dLDoor is detected as open when the motor is operating.dSDoor is detected as open while it is trying to lock the door.E2Jammed KeyE3MICOM is attempting to drive the motor but is not getting any response signals…EEEEModel option Error detected during Quick Test Mode.FLDoor fails to lock after 3 attempts.HrHeater Relay Failure (No Heater Relay Check Signal).LEWater Level Sensor TroubleLODoor fails to unlock after 3 attempts.ndThe water level fails to drop below the Reset Water Level within 15 minutes.nFWhen the filling continues for more than 16 minutes or there is no change of…OEA fault is detected in the water level sensor; data (frequency) shows the water…PFPower failure occurred during the washing cycle (informational, not a true…SrSystem Relay (Main Relay) FailureSUdSSuds is detected during the washing session; if the washer is in suds period…tEAbnormal high/low temperature or resistance (Thermal sensor or PBA) resistance.

Service modes (10)

  • Board Input Test Mode["Activate the Special Test Mode first.","Press the Extra Wash Key."]
  • Continuous Run Mode["Press Delay Start Key and Extra Rinse Key together for 3 seconds during Power On State (Normal…
  • Cycle Count Check Mode["Activate the Special Test Mode first.","Press the Signal Key."]
  • Diagnostic Code Check Mode["Activate the Special Test Mode first.","Press the Silver Wash (Rinse Water +) key."]
  • EEPROM Reset Mode["The unit needs to be on.","Press Delay Start Key, Signal Key and Power Key at the same time."]
  • Fast Time Down Test Mode["Activate the Special Test Mode first.","Press the Temp Key to forward the program to the next…
  • Quick Spin Test Mode["Enter Special Test Mode first.","Press the Delay Start and Silver Wash Keys (Rinse Water + Key)…
  • Quick Test Mode["Plug in and turn on the unit.","Press Spin Key, Soil Level Key and Power Key at the same time."]
  • S/W Version Check Mode["Activate the Special Test Mode first.","Press the Soil Level Key."]
  • Special Test Mode["The washer must be on.","Press the Signal and Extra Rinse Keys for 3 seconds or until the unit…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass