mypros+
Model reference

Whirlpool WTW6200SW2

Washer

19 documents33 error codes7 service modes

Available documentation

Service Manual

  • Cabrio Automatic Washer Job Aid84 pg
    Covers this model
  • Cabrio Automatic Washer84 pg
    Covers this model
  • Cabrio™ Automatic Washer Job Aid84 pg
    Covers this model
  • Cabrio™ Automatic Washer Job Aid84 pg
    Covers this model

Tech Sheet

  • Whirlpool Cabrio Washer WTW6400SW2 Tech Sheet16 pg
    Covers this model
  • Tech Sheet W10026571 Rev C16 pg
    Covers this model

Service Flash

  • Service Pointer 8178742 - Cabrio and Bravos Washers Intermittent Water Leak4 pg
    Covers this model
  • F1 Error Code Service Pointer Cabrio Washer2 pg
    Covers this model
  • Service Pointer - Control Displays F51 Code1 pg
    Covers this model
  • F1 Error Code Service Pointer - HE Top Load Washers2 pg
    Covers this model
  • Service Pointer - 8178767 (F1 Error Code)2 pg
    Covers this model
  • Service Pointer 8178742 Intermittent Water Leak4 pg
    Covers this model
  • Service Pointer - W10611623 - Drain Hose Installation6 pg
    Covers this model

Training

  • Training Pointer - Replacement Bearing Procedure for Top Load, Direct Drive Washers16 pg
    Covers this model

Job Aid

  • Instruction Sheet for Bearing Replacement Procedure12 pg
    Covers this model

Quick Reference

  • Quick Reference Manual4 pg
    Covers this model
  • Manual de referencia rapida2 pg
    Covers this model

Installation Guide

  • Instruction Sheet2 pg
    Covers this model

Other

  • 81787671 pg
    Covers this model
MyPros+ Max

Diagnose your Whirlpool WTW6200SW2.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (33)

CodeMeaning
dLDoor Lock FailuredUDoor Unlock FailureF1Pressure Signal Out-of-RangeF2Keypad/User Interface FailureF30Saved fault code for Long Fill (LF).F32Saved fault code for Long Drain (Ld).F40ATC Thermistor Open/ShortF41Motor RPS Thermistor Open/ShortF42Heater Thermistor Open/Short (Not used)F50Motor StalledF51Motor RPS FailureF52Motor Stop FailureF53Motor Control OvertempF54Motor Control OvercurrentF60Saved fault code for Primary Control Failure.F68Saved code for Primary Control Failure (range F60-F68).F70Saved fault code for Overloaded (oL).F71Saved fault code for Suds Detection (Sd).F72Basket Re-engagement FailureF80Saved fault code for Door Lock Failure (dL).F81Saved fault code for Open/Close Door Lid (lid).F82Saved fault code for Door Lock Failure (dL).F83Saved fault code for Door Unlock Failure (dU).F84Saved fault code for Door Lock Failure (dL).F85Saved fault code for Door Lock Failure (dL).HCHot, Cold ReversedLdLong DrainLFLong FilllidOpen/Close Door LidoLOverloaded
View all 33 error codes
PoPump Out (lid opened)SdSuds DetectionuLUnbalanced Load

Service modes (7)

  • Automatic Diagnostic Test1
  • Automatic Diagnostic Test Mode1. Washer must be in standby mode (plugged in with all indicators off, or with only Clothes Clean…
  • Console and Indicators Diagnostic Test1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release the following…
  • Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release within 4 seconds
  • Manual Diagnostic Test1
  • Manual Diagnostic Test Mode1
  • Pressure Transducer Calibration1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass