Model reference

Whirlpool WTW6600TB

Washer

6 documents32 error codes4 service modes

Available documentation

Service Manual

DIAGNOSTIC GUIDE - Service Technician Manual16 pg
Covers this model
Job Aid - Automatic Washer With 6th Sense™ Technology84 pg
Covers this model
Automatic Washer with 6TH Sense™ Technology84 pg
Covers this model

Service Flash

Clothing Tangling and Balling2 pg
Covers this model
Service Pointer - Control Displays F51 Code1 pg
Covers this model
Service Pointer 8178742 Intermittent Water Leak4 pg
Covers this model

MyPros+ Max

Diagnose your Whirlpool WTW6600TB.

Step-by-step diagnostics from the service manual
Test values, resistance specs, and wiring references
Verified part numbers when replacement is needed

Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

M+

M+ Max·Whirlpool Washer

dL on my Whirlpool WTW6600TB

M+

Door/lid lock failure — lid is not

From Tech Sheet W13180966, p.18:

1.Access service mode to confirm the active fault code and read stored error history.

2.Measure door lock assembly resistance across PTC terminals. Expected: ~200 ohms cold.

3.Inspect strike and latch alignment. A misaligned strike prevents the switch stack from closing.

Part W10810403

Door lock assembly

Error codes (32)

CodeMeaning

dLDoor/lid lock failure dUDoor/lid unlock failure F1Primary control failure in the machine control assembly.F2Keypad/User Interface failure F30Long fill saved fault code F32Long drain saved fault code F40ATC (Automatic Temperature Control) thermistor is detected to be open or…F41Motor rotor position sensor (RPS) thermistor is detected to be open or shorted.F42Heater thermistor is open or shorted (not used on these models).F50Motor stalled F51Motor rotor position sensor (RPS) failure.F52Motor stop failure F53Motor control overtemperature F54Motor control overcurrent F60Primary control failure (one of the F60-68 range codes).F70Overloaded F71Suds detection F72Basket re-engagement failure F80Door lock failure F81Open/Close door lid F82Door lock failure F83Door unlock failure F84Door lock failure F85Door lock failure HCHot and cold inlet hoses are reversed.LdWasher is taking too long to drain water from the wash tub LFWasher is taking too long to fill lidLid opened oLOverloaded PoPump out activated

View all 32 error codes

SdSuds detected uLUnbalanced load detected

Service modes (4)

Automatic Diagnostic Test Mode1. Ensure washer is in standby mode (plugged in with all indicators off, or with only Clothes…
Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release the following…
Manual Diagnostic Test Mode1
Pressure Transducer Calibration1

Full entry steps, exit procedures, and test sequences are available in Max.

Related Whirlpool washer models

78,000+ service manuals · 160,000+ error codes · 55+ brands

$29/month · Cancel anytime · Or $9.95 3-day pass