mypros+
Model reference

Kenmore 110S-6070

Washer

4 documents30 error codes9 service modes

Available documentation

Tech Sheet

  • Tech Sheet and Wiring Diagram - 397008931 pg
    Covers this model
  • Tech Sheet 8543719 110 2506650016 pg
    Covers this model

Service Manual

  • Instruction Sheet - 856703616 pg
    Covers this model
  • Instruction Sheet - 854371916 pg
    Covers this model
MyPros+ Max

Diagnose your Kenmore 110S-6070.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (30)

CodeMeaning
CAAverage current limit trip; a 2-second average current draw greater than 5.55…CECommunications error; breakdown in communication between the machine controller…CIInstantaneous current limit trip; a spike of 26 Amps was detected instantly at…dLDoor Lock FailuredUDoor Unlock FailureErProcessor reset error; the control failed to save cycle information during a…F1Primary Control FailureF2Keypad/User Interface FailureF40ATC Thermistor Open/ShortF41Motor RPS Thermistor Open/ShortF42Heater Thermistor Open/ShortF50Motor StalledF51Motor RPS FailureF52Motor Stop FailureF53Motor Control OvertempF54Motor Control OvercurrentF72Basket Float FailureHCHot, Cold ReversedLdLong drain; it takes longer than 5 minutes to pump out water to the point where…LFLong fill; the water fill time exceeded 10 minutes, causing the water valves to…lidOpen/Close Door LidLSLid switch error; the control cannot detect lid switch opening/closing…obOff balance; the motor controller detected an unrecoverable off-balance…oLOverloadedPFPower failure detected during a running cycle; the washer lost power mid-cycle.PoPump Out (lid opened)SdSuds DetectionSLSuds lock; excessive suds detected and the unit was unable to clean out suds…SrStuck relay; the relay has failed in the closed position so the machine…uLUnbalanced Load

Service modes (9)

  • Automatic Diagnostic Test Mode1. Ensure washer is in standby mode (plugged in with all indicators off, or with only the Clothes…
  • Automatic Service DiagnosticsControl must be in Off state. Perform Key Dance within 5 seconds
  • Console and Indicators Diagnostic Test Mode1. Plug in washer or reconnect power. 2. From Standby (Off) Mode, press and release the following…
  • Console Keypad and LED TestControl must be in Off state. Perform Key Dance within 5 seconds
  • Manual Diagnostic Test Mode1
  • Manual DiagnosticsControl must be in Off state. Perform Key Dance within 5 seconds
  • Nutate and Recirculate TestControl must be in Off state. Perform Key Dance within 5 seconds
  • Spin and Drain TestControl must be in Off state. Water should be present in the unit. Perform Key Dance within 5…
  • Water Inlet and Dispenser Valve Operating PS TestControl must be in Off state. Perform Key Dance within 5 seconds

Full entry steps, exit procedures, and test sequences are available in Max.

Related Kenmore washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax