Model reference
Samsung WA46CG3505AVA4
Washer
2 documents31 error codes8 service modes
Available documentation
Service Manual
- Washing Machine (Top-loading) Service Manual21 pg
- Samsung Washing Machine WA3500C Service Customer Repair Guide31 pg
MyPros+ Max
Diagnose your Samsung WA46CG3505AVA4.
- Step-by-step diagnostics from the service manual
- Test values, resistance specs, and wiring references
- Verified part numbers when replacement is needed
Start diagnosing
$29/month · Cancel anytime · Or $9.95 3-day pass
Error codes (31)
CodeMeaning
1CThe water level sensor is not working properly.3CWashing motor is not operating properly.4CWater is not supplied to the washer.4C2Cold water supply hose is not firmly connected to the cold water tap or is…5CWater is not draining from the washer.8CMEMS sensor error.8C1MEMS PBA error due to disconnection or defective MEMS PBA.8C2MEMS PBA error9C1The electronic control needs to be checked (over voltage error).9C2Low voltage detected.ACCommunication errorAC6Inverter communication problem.BC2Switch error (main relay error)CLChild Lock mode activedCOperating the washer with the door open.DC1The door lock switch unit is not inserted or is damaged.DC2The door lock switch unit is defective or wire is disconnected.HCHigh temperature heating check.HC1Heater faultLCWater leakage detected or drain hose positioned incorrectly.LC1Water leakageOCWater overflowed.PCPosition of the clutch cannot be detected.PC1After clutch position is detected, the signal from the clutch hall sensor is…TC1Washing temperature sensor fault.TC2Dry temperature sensor fault.TC3Faulty and incorrect connections of the dry condensing sensor.TC4IPM temperature is abnormally high or main PCB fault or freezing in winter…UbSpinning does not work due to unbalanced load.UCPower condition faultView all 31 error codes
Service modes (8)
- Automatic check modeEnter Smart Install mode, then press Start/Pause while 'AS' is displayed.
- Automatic Mode Result EnquiryWhile 'AS' is displayed, press 'Delay End + Start/Pause' simultaneously.
- Diagnostic Code CheckEnter Smart Install mode, then press Soil while 'AS' is displayed
- Manual check modeEnter Smart Install mode, then press Delay End while 'AS' is displayed.
- S/W version CheckEnter Smart Install mode, then press Temp while 'AS' is displayed.
- Smart Care (Self-Diagnosis)["When the washer detects an issue and displays an information code, press and hold Soil for 3…
- Smart InstallFrom Standby, set the scheduled time to 17:00, then press and hold Start/Pause for 7 seconds.
- Smart Install (Test Mode Entry)["From standby, set the scheduled time (Delay End) to 17:00.","Press and hold Start/Pause for 7…
Full entry steps, exit procedures, and test sequences are available in Max.
Related Samsung washer models
78,000+ service manuals · 160,000+ error codes · 55+ brands
Get Started$29/month · Cancel anytime · Or $9.95 3-day pass