mypros+
Model reference

Samsung WF337AAL

Washer

4 documents30 error codes11 service modes

Available documentation

Service Manual

  • LG Samsung WF203ANWYE Service Manual Alignment & Adjustment9 pg
    Covers this model
  • Washing Machine Service Manual4 pg
    Covers this model
  • LG Samsung Samsung WF328AAW Service Manual68 pg
    Covers this model
  • wf328aaw-service-manual68 pg
    Covers this model
MyPros+ Max

Diagnose your Samsung WF337AAL.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass

Error codes (30)

CodeMeaning
2EVoltage for motor control bus is over or under specified limit.3EMotor not running properly.7EAG kit is out of order (check wire harness and PCB).8EMotor speed sensor problem.9EHigh/Low voltage detected.AEProblem with control.bEJammed Key.dcDoor is open when washer is running.dEThe door will not unlock.dFWasher failed to lock the door.dLDoor is unlocked when washer is running.dSDoor is detected as open while it is trying to lock the door.E2Jammed KeyE3MICOM is attempting to drive the motor but is not getting any response signals…EEEEModel option error detected during Quick Test Mode.FEElectric service was lost when washer was running.FLDoor fails to lock after 3 attempts.HEWater temperature control problem (Heater Control problem).HrHeater Relay Failure (No Heater Relay Check Signal).LEWasher has tried to fill but has not reached the proper water level.LODoor fails to unlock after 3 attempts.ndWasher is not draining; it can also mean that the unit senses a small clog…nFWasher has tried to fill but was unsuccessful.OEHigh current detected.PEA fault is detected in the water level sensor.PFPower failure detected during washingSrSystem Relay (Main Relay) FailureSUdSToo many suds are detected during the washing session; the unit is put on hold…tETemperature sensor problem.UEUnbalanced load prevented the washer from spinning.

Service modes (11)

  • Board Input Test Mode["Activate the Service Mode first.","Press the Extra Wash key during Service Mode."]
  • Continuous Run Mode["Press Delay Start Key and Extra Rinse Key together for 3 seconds during Power On State (Normal…
  • Cycle Count Check Mode["Activate the Service Mode first.","Press the Signal Key during Service Mode."]
  • Demo ModeHold down Delay Start + Signal + Extra Wash buttons for 5 seconds simultaneously in power on state.
  • Diagnostic Code Check Mode["Activate the Service Mode first.","Press the Silver Care (Rinse Water +) key during Service…
  • EEPROM Clear Mode["The unit needs to be on.","Press Delay Start Key, Signal Key, and Power Key at the same time."]
  • Fast Time Down Test Mode["Activate the Service Mode first.","Press the Temp key during Service Mode."]
  • Quick Spin Test Mode["Enter Service Mode first.","Press the Delay Start and Silver Care Keys for 3 seconds."]
  • Quick Test Mode["Plug in and turn on the unit.","Press Spin Key, Silver Care Key, and Power Key at the same time."]
  • S/W Version Check Mode["Activate the Service Mode first.","Press the Soil Level Key during Service Mode."]
  • Service Mode["The washer must be on.","Press the Signal and Extra Rinse Keys for 3 seconds or until the unit…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Samsung washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass