mypros+
Model reference

Electrolux EIFLW55H

Washer

4 documents57 error codes14 service modes

Available documentation

Service Manual

  • Technical Service Manual 2010 Wave Touch and IQ Touch Front Load Washer_19418590 pg
    Covers this model
  • FRONT-LOAD WASHING MACHINE Model No. EIFLW55H8 pg
    Covers this model
  • Use & Care Guide - IQ-Touch™ Front-Load Washer32 pg
    Covers this model
  • Wave-Touch™ and IQ-Touch™ Front-Load Washer Models EIFLW55H & EWFLW65H Technical Service Manual92 pg
    Covers this model
MyPros+ Max

Diagnose your Electrolux EIFLW55H.

  • Step-by-step diagnostics from the service manual
  • Test values, resistance specs, and wiring references
  • Verified part numbers when replacement is needed
Start diagnosing

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax

Error codes (57)

CodeMeaning
E00No failure code experienced; no error stored in memory.E11Fill time too longE13Water leak detectedE21Drain time too longE31Electronic pressure switch failure.E32Pressure sensor calibration problem.E35Water level pressure sensor errorE38Pressure sensor difference errorE41Door lock errorE42Door unlock errorE43Control board errorE44Door open errorE45Door lock relay error on main control board.E46Door command sense failure.E49Door incongruence between door line and door sense.E52Motor control signal errorE53Low voltage to Motor Control Board.E54Motor control overcurrent errorE55Under speed condition.E57Motor control high current errorE58Motor control high current error on phase.E59Motor control no tachometer signalE5AMotor control heatsink overtemperature on speed control board.E5BMotor control high voltage on DC bus of speed control board.E5CMotor control low voltage on DC bus of speed control board.E5DMotor control communication errorE5EMotor control communication error between main board and motor control.E5FMotor control errorE61Heater error during washE62Heater overtemperature
View all 57 error codes
E66Heater relay error on main control board.E67Heater sensing relay failure.E68Heater current leakE69Heater NTC breakE6AHeater NTC shortE6CDispenser NTC breakE6DDispenser NTC shortE71Drum water NTC (tub heater thermistor) failure.E74Wash temperature does not increase.E91Communication error between user interface (UI) and main board (MB).E92Communication errorE93Main board configuration error.E94Cycle configuration error on main board.E95Communication error between main board and motor control during startup.E97Console or Main Board control problem.E98Console control problem.E9FCommunication protocol error.EA1Power supply frequency out of limits.EA2Power supply voltage too high.EA3Power supply voltage too low.EA5Main voltage sensing failure.EABCommunication error between main board and user interfaceEAELine safe relay sensing failure.EF1Clogged drain pump.EF2Too much soap detected.EF5Incorrect water temperature.EF8Key stuck on control panel.

Service modes (14)

  • Clear Stored Error Codes["1
  • Demo Mode (IQ Touch)["1
  • Demo Mode (Wave Touch)["1
  • Diagnostic Mode (Error Code Reading)["1
  • Diagnostic Test Mode["Press the CANCEL button to enter standby mode.","Within 10 seconds after pressing CANCEL, press…
  • Diagnostic Test Mode (Component Test)["1. Press the CANCEL button to enter standby mode.","2. Within 10 seconds after pressing CANCEL…
  • Installation Cycle (IQ Touch)["1
  • Installation Cycle (IQ-Touch)["Empty washer drum and close door.","Wake washer by pressing any button.","Rotate cycle knob to…
  • Installation Cycle (Wave Touch)["1. After plugging in the washer the first time, wake up the washer by pressing any button and…
  • Installation Cycle (Wave-Touch)["After plugging in washer the first time, wake up by pressing any button.","Follow prompts on LCD…
  • Read Error Codes["Wake the washer by pressing any button (except CANCEL).","Press and hold the CANCEL and START…
  • Reset (IQ Touch)["1
  • Reset (Wave Touch)["1
  • Reset Factory Defaults (IQ-Touch)["Wake machine.","Press and hold the spin speed and soil selection keys simultaneously until you…

Full entry steps, exit procedures, and test sequences are available in Max.

Related Electrolux washer models

75,000+ service documents · 20,000+ error codes · 100+ brands

Get Started

$29/month · Cancel anytime · Or $9.95 3-day pass · Plus applicable tax